Your cart is empty.
Your cart is empty.For countersinking and deburring in a wide range of ferrous and non-ferrous materials. Radially relieved single cutting edge for fast stock removal without chatter in portable and machine applications. Tools can be re-sharpened using an axial relief sharpening fixture or with a mounted grinding wheel inserted into the hole.
Noel
2025-07-14 11:40:28
Works fine and holds an edge. Finally, something manufactured with quality vs. the CHINESE JUNK out there.
nick
2025-07-13 21:07:30
Best countersink i have ever come across ,500 plus 1/4 x 20 counter sunk holes in 316 stainless steel and is still going strong,run this properly with cutting fluid and low rpms and it will go the distance.
Write Reason
2025-06-14 14:52:29
Does an excellent job, and holds up well.
LD
2025-04-13 10:21:08
Nicely ground and finished countersink.Compared to the cheap countersinks usually included in hardware-store drill sets, this one is much higher quality and worth buying if you are countersinking holes in steel.Then again, it costs as much as the entire set of woodchuck drills. Works in wood, too!
beth
2025-03-10 10:18:33
I counter sink a lot of brass and aluminum and this thing leaves a beautiful finish with a nice clean cut.
Jim
2025-02-26 14:03:05
Great cutting tool, works great!
Ron
2025-02-07 18:58:13
Deburred without all the chatter on 1/4 mild steel. Very happy
Recommended Products
