Your cart is empty.
Your cart is empty. The ADXL345 is a small, thin, ultralow power, 3-axis accelerometer with high resolution (13-bit) measurement at up to ±16 g.
Digital output data is formatted as 16-bit twos complement and is accessible through either a SPI (3- or 4-wire) or I2C digital interface.
Supply voltage range: 3V to 5V
Digital-output triple-axis accelerometer with a programmable full scale range of ±2g, ±4g, ±8g and ±16g and integrated 16-bit ADCs
Accelerometer normal operating current: 450µA
Ultralow power: as low as 23 μA in measurement mode and 0.1 μA in standby mode at VS = 2.5 V (typical)
Sleep mode current: 8µA
Communication: SPI (3- and 4-wire) and I2C digital interfaces
Package inlcuded:
2 X GY-291 ADXL345 3-axis digital acceleration module
2 X 8P pin header
Sleewok
2025-07-20 10:19:52
Wired up following klipper docs after locating the pin out for my pz2w. Worked perfectly. I tested both modules.
smp
2025-04-14 14:44:43
used to run input shaper on ender 3 with raspberry pi zero.
phoenix_jmed
2025-03-29 12:38:02
works well
Greg and Renee
2025-03-08 13:48:11
Bought this with the intent of setting up Klipper's input shaper on my core xy 3d printer. The first chip I tried was dead on arrival, but the second worked perfectly. Im happy enough since I only needed one, but maybe be cautious if you need two chips.The chips arrived in a small padded mailer, each chip was individually wrapped in an anti static bag with a 6 pin GPIO male header inside.
Charles S.
2025-02-24 09:38:31
I found multiple wiring diagrams to connect this to an RPi for klipper input shaping and I ended up having to desolder and resolder but in the end, this worked flawlessly.
Michael
2025-01-27 21:03:21
No problems, they work as described.
Daniel D
2025-01-18 13:45:55
Only one worked.
JVZ
2024-11-14 11:13:19
Was trying to pair it up with a Seeed Studio XIAO RP2040 (that I bought the same day at Amazon) to configure input shaper on my 3d printer. The first adxl345 was DOA. The second one initially worked, was able to get readings in the console. Then, after a minute or so, smoke. RP2040 was fried, literally. Hopefully the USB on my host was not damaged. Was a waste of about 20 dollars. Do NOT recommend
Recommended Products
