Your cart is empty.
Your cart is empty.
【Features】
- Used in electronic equipment, mold manufacturing, precision machinery, hardware parts, mechanical parts, stamping parts and hardware manufacturing.
【Specifications】
- Name: stainless steel sheet（Brushed Finish）
- Material: 304 stainless steel
- Length: 4"-12"
- Width: 4"-12"
- Thickness: 14-28 Gauge(0.5-2 mm)
【Buyer's remarks】
- Light shooting and different displays may cause the color of the items in the pictures to be slightly different from the real ones.
- Please allow a difference of 1-3mm due to manual measurement.
- Due to the manufacturing process and inevitable objective reasons, slight scratches may appear on the surface.
Legend Campbell
2025-08-09 17:38:45
Its real stainless, not sure where these other people get their info but true stainless is non magnetic LMAO magnetic stainless found on appliances are made with a mixture of iron to allow magnets to hang... The more you know...Only down side i see if you wanted double sided, one side is painted and they are wrapped in a baggie but no protective film, my case I'm just making mounting brackets for car mods so it doesn't matter to me!
daniel welch
2025-08-02 13:57:32
Just what I was looking for to make a drain grate repair.
Andrew
2025-06-29 18:55:58
It’s a 8x8 pice of sheet metal…. So that’s good.
Tom
2025-06-17 13:43:36
Obviously not stainless, Both are scratched to high heaven on the metal side.No protective film, a Obviously pre painted side. Absolutely useless.
Jim Stein - Author SF&F
2025-06-06 16:20:40
Percect for patching bottom of RV slide out room. Just needed to use a couple drops of oil while drilling. This SS stuff is hard as nails.
Apu Blicname
2025-05-24 18:18:22
It was exactly what I was looking for, a perfectly flat square piece of stainless steel. All the angles were 90 degrees and the flatness was essentially 2D. Don’t even get me started on the stainlessness of the steel. Let’s just say red wine wiped right off it. Highly recommended!
Eric Titov
2025-05-22 14:23:49
Material looks good but it is several thousands of an inch from being .060†or any spec they advertise this to be. With my micrometer I am getting .055, I thought maybe my micrometer was off a bit so I checked it with 2 other mics and 2 sets of dial calipers with same results, MATERIAL IS NOT TO SPEC…
Glen Clabaugh
2025-03-12 12:47:07
I don’t know what this metal actually is, but it isn’t stainless steel because it isn’t magnetic. So totally useless and I can’t return it.Caveat emptor.
Tremblay
2025-03-05 10:03:14
C'était pas la bonne plaque que je voulais mais je la garde pareille on sait jamais
Customer
2025-02-10 14:04:56
Exactly as described.
Claude
2025-01-22 18:35:53
Bien
Fenn
2025-01-03 14:54:38
used this on a large laser cutter where I wanted something thin and delicate (paper, leather, latex, rubber) to be cut but not flop down below the item.
Russ Salo
2024-12-18 12:10:43
Fine
Recommended Products
