Your cart is empty.
Your cart is empty. Description:
Feature:
On-board DIP switch, you can easily adjust the drive segments
Terminal power connector for easy connection drive power
Compatible with 12 / 24V drive scheme
Suitable for 42 stepper motor drive, 3D printers and DIY
Specification:
Size: 42 x 42 x 15mm
Fixed: 3mm
Pitch: 1400 x 1400mil (35.56 x 35.56mm)
Logic voltage: 5V
Input voltage: 12-30V
Ports: Digital
Interface: Direction, enable, speed
Applicable module: A4988, DRV8825
Package included:
1 x 42 stepper motor drive Expansion Board
1 x A4988 Stepper Motor Driver
1 x DRB8825 Stepper Motor Driver
2 x Heatsink
M. Zambrano
2025-06-07 18:13:48
Very easy to connect to an Arduino Uno. Connect the Arduino power jack to a 9volt or above power supply. Then connect 6 pins from the arduino to the carrier board (5v, Vin, grounds, direction, and step) and you can easily control a stepper motor with greater accuracy and less noise. Be sure to adjust the potentiometer for correct current supplied to the stepper to prevent overheating the stepper and this module. Using lower current results in even less noise from the stepper, but you will sacrifice some power.
dennis
2025-02-07 17:19:28
There are dip switches that has no understanding on what is up. Total frustrating wait to get it then they send a hand full of electronics.I will be sending it back.
Recommended Products
