Your cart is empty.
Your cart is empty.
Note:
The high-voltage module should avoid the use of electricity in high voltage no-load . (Power must be adjusted to a suitable distance to the high-voltage output line , battery capacity is proportional to the distance and the use of the high-pressure arc ( not a voltage as high as possible , you must provide enough current ) .
Experimental test of the arc distance from short to long , Do not exceed the maximum arc distance electricity, energy can not be released due to high pressure , can easily damage the module. )
Work: intermittent , continuous work does not allow more than 1 minute and the output side does not allow shorting . Improper voltage and long working hours easily damaged module.
Product description
Size：24x22x63mm
Input voltage: DC 3V to 6V
Input current: 2A - 5A
High pressure type: the type of pulse current
Output voltage: 400000V(Please pay attention to safety)
High pressure discharge distance between: 10mm - 20mm
The output high voltage wire length: 100mm
Input power cord length: 100mm (the red line is positive)
Jeanette Aviles Aquino
2025-08-04 14:35:43
Si le pones una batteria de 9v y lo tocas te tumba el brazo, te arrepentiras
stewart Thorpe
2025-07-26 15:08:38
Good price, high quality, good shipping time.
Blake C.
2025-07-24 10:40:35
Very easy to utilize.
Purchaser
2025-05-20 09:39:53
2 of the three worked at 8 volts ok, but very very hot with even short run time. At 12 volts, one melted the plastic case in 5 seconds. The third didn't work at all. All of the above at 10mm arc length. Junk in this batch. lets see what the replacements do....
Ron
2025-02-12 13:12:32
The media could not be loaded.
Thorr
2025-01-12 21:02:27
i use them as ignitors for my rocket engine. they ignite a mix or propane and air at great flows.
Nick
2025-01-04 17:45:19
Units fail nearly immediately with spaced gap even at low under 6 volt . Hassle if being used and installed. I have another set the 800-1000kv that work well and reliably . Look elsewhere
Recommended Products
