Your cart is empty.
Your cart is empty.Product Description
Customer
2025-08-20 16:57:04
I bought these rollers to make a sliding bed for the back of my pick up. Attached to the bottom of three-quarter inch plywood has given me the ability to pull this plywood in and out of the truck with ease. I have about 300 pounds of tools attached to the plywood. An inexpensive answer to a very expensive drawer slide for a pick up. And what a back saver.
Customer
2025-06-27 11:35:12
These are just what I needed to make a heavy duty roller stand for my shop.I tried to put them close together in the center to support smaller items and the outboard ones support wide items
Marbar74
2025-06-26 10:38:16
Only reason for the low rating is because they advertised the quietness of the product was superior as of the competition. They are great, working as the should, but they are as loud as eny other out there.
Dan from WI
2025-05-01 10:20:43
Liked that product was as described and shipped promptly.
Thanatyr
2025-01-21 10:24:30
I used these for support in a turn-table style work holding jig for polishing (essentially a 24" wide 3 jaw chuck). They are more than capable of the load, and are of extremely uniform dimensions from one bearing to the next. They are super loud at even moderate RPM's and they appear to be abrading from the inside out. Like I said, I have used them in a very off-label way, so your mileage may vary. Used solely to move heavy sheet goods at velocities not prone to cause injury, they would be spectacularly good.
Customer Review
2024-11-21 14:28:12
As the picture entails, these are fairly large roller bearings that can be used for extremely heavy items (up to 400 lbs each!). I don't have the capability to test its upper limits in my small garage shop, but unless you're moving 2 foot-thick slabs of granite around, I'm pretty sure these puppies could stand up to just about anything.They all seem to roll very freely and have two pre-drilled holes for mounting onto a surface. My plan is to use these to make omnidirectional infeed roller stands for my table saw. I currently own a couple of standard, linear roller stands, but I like the flexibility of being able to move my boards in any direction I need them to go. Definitely overkill for my needs, but I'd rather overbuild than underbuild when safety is a concern.5 out of 5 stars - Quality product, excellent value. I wouldn't hesitate to recommend these. The banana was delicious, by the way.
Recommended Products