Your cart is empty.
Your cart is empty.Product Description
Hi, here comes the seller Partswcgg. As a seller with rich experience in the automotive parts aftermarket, providing high quality products has always been a goal for our company. Go ahead and Let’s make it easy for you.
White is ground, connect with red wire for high mode and function as stop/tur/brake lights. Each 4 inch round red light includes 24 LED super bright led chips.
White is ground, connect with black wire for low mode and function as tail/running/marker lights. Each 4 inch round red tail light includes 24 LED super bright led chips.
Of course, every 4 inch round led trailer tail light is flush mount with required lights rubber grommets and 3-prong wire plug;
These 4 inch round led lights are widely used for almost all 12v dc vehicles such as Trucks, Trailers (Box, Camper, Transport), Caravans, UTVs, Motor Homes, Earthmoving & Mining Equipment, Forklifts, Buses, Coaches etc.
White is ground, connect with red wire for high mode and function as backup/reverse lights. Each 4 inch round white trailer backup light includes 24 LED super bright led chips.
White is ground, connect with black wire for low mode and function as tail/running/marker lights. Each 4 inch round white trailer reverse light includes 24 LED super bright led chips.
Each 4 inch round trailer light is in 5.3" Diameter x 1" deep and you may need to drill a hole about 4.6” to insert it in.
Every 4 inch round led light is sealed, corrosion resistant and IP65 waterproof;
Robert Burns
2025-09-05 10:18:33
LEDs have been great so far, nice and bright compared to the stock halogens.One thing I would mention though is the grommets provided WILL NOT fit all vehicles depending how big the hole is....you are better off reusing the old grommets if you are buying these as an upgrade.
Emmett
2025-08-21 21:31:12
I have to concur with Robert Burns about re-using my old grommets in my Knapheide utility bed. I could not get the supplied grommets to work. However, my old gooseneck stock trailer needed replacement tail and turn signal lights. Since I had kept the old Knapheide lights, I thought that they would be a no-cost solution. It turns out that I finally got the new grommets to work because I had free access to both sides of the trailer mounting holes.My conclusion is: Use your old grommets if you don't have full access to both sides of the mounting hole (my utility bed did not). The new grommets will likely work if you have free access to both sides of the mounting hole but, even then, don't be surprised if there is still considerable strain in getting the lights installed using the new grommets.
LEW’S storage
2025-06-17 18:50:49
The quality of the lenses so far is very nice looking. Although the rubber seals around the lens the thickness is very thin.
Peter M Carroll
2025-05-30 11:33:06
The lights were easy to install and work as they should.
Ordinary Man
2025-03-25 13:57:32
They look great in the box. I'll be replacing the rear lights on our bus with these lights.
Grant G
2025-02-17 16:33:12
Do yourself a favor and get trucklites or grotes. These grommets are quite literally plastic and you’ll break the light before you get them in the grommet. Vaseline, hot water, nothing worked. Junk.
charles rollins
2025-01-17 17:01:05
I bought these to install into a utility bed i bought and installed on my truck it had one light out so I decided I would just replace of all them to upgrade to LED tge brake lights are alot brighter and so is the reverse lights and backing up a truck with a large utility bed you need brighter reverse lights to see better at night
L. Dwernychuk
2024-12-19 11:24:06
Easy install seem to be good quality. We’ll see how they stand up. so far so good.
Recommended Products