Your cart is empty.
Your cart is empty.Product Description
Specifications:
- Working Voltage: DC 12V
- Normally Opened Compatible Load: AC 250V/10A, DC 30V/10A
- Action Time (Under Rated Voltage): Less Than 10ms
- Release Time (Under Rated Voltage): Less Than 5ms
- Power Indicator (Green), Relay Status Indicator (Red)
Connection:
Output Interface:
- NO1: Relay Normally Open Interfaces , Relay Before Floating, Shorted Pull With COM1
- COM1: Relay Common Interface
- NC1: Normally Closed Port, COM1 Relay Shorted Before and After The Pull- Vacant
- NO2:Normally Open Relay Interface, Relay Before Floating , Pull Back and COM2 Short
- COM2: 2 Common Interface Relay
- NC2: 2 - Way Normally Closed Relay Interface Relay Short Front and COM2 , Pull Vacant Post
Input Interface:
- DC +: Positive Power Supply DC 12V
- DC-: Negative Power Connection
- IN1: 1 Channel Signal to Trigger The End , You Can Set High or Low Level Control Relay
- IN2: 2 Channel Signal to Trigger the End , You Can Set a High or Low Level Control Relay
High or Low Level Trigger Select:
- S1: High and Low Level Trigger for Channel 1
- S2: High and Low Level Trigger for Channel 2
- Low Level Trigger when “COM” Connecting “Low” to Short Circuit
- High Level Trigger when “COM” Connecting “High” to Short Circuit
Hard Bush
2025-07-30 14:04:31
Works like described Good!
Rich
2025-07-15 16:47:24
The light on my garage door opener has been flakey for sometime now, refusing to go off on it's own and needing to beat on the 'light' button a few times before going off. Finally, it was stuck on for good.Took the controller board out and, sure enough, the "sugar cube relay" was stuck on.It's a common enough part but buying ONE will cost $20 after shipping.Never mind, these relays has the same specs for a fraction of the price.Took one and put it in the garage door opener, and have 7 for spare. lol
M Burris
2025-07-08 10:38:48
Got these for a small project where I needed two relays to activate based on the signal from an Adafruit Trinket MO. Work well.
T. COTON
2025-03-29 13:59:23
At first I thought I got lemons because they would not click at if applying 5V DC on low power side according to description. Then I applied 12V DC and they clicked, then I forgot to share the ground when using an ESP32 5V DC sending a 3.2V signal that would trigger both relays at the same time instead of separately, once grounds shared, they worked properly.
Customer
2025-01-20 14:57:34
Just bought these for a small model train project. I’m now having to return them because neither of the two relays on any of the 4 modules work…. Cheap garbage
Libby Elliott
2025-01-10 16:47:41
I bought these relays for my new CNC machine for wood carving.Nice product. Exactly what I was expecting.Work perfect!
JTK
2024-12-12 15:43:12
Unit allows using PNP or NPN drivers that cannot drive the current of a relay coil alone. Easily switched from high or low trigger. LEDs help indicate power and state of the inputs. Dry pleased with this simple but well built device. Terminal blocks are not great, but they do function.
Customer
2024-12-05 15:48:36
These work well. I used them with ESPHome to operate my garage doors.
Recommended Products