Your cart is empty.
Your cart is empty.Product Description
mattvw
2025-09-04 11:13:45
These are very good quality. I have used them with a raspberry pi camera to add tilt and pan functionality.It was a little bit of work to get the camera to attach to the mount and to get it to stay in place but I’m sure there were better ways than how I did it.But functionality, it works well and wasn’t much work to get put together!
Tom Thompson
2025-08-14 16:56:40
At 50Hz a pulse width of 0.5ms corresponds to (0 deg) and a pulse width of 2.5ms corresponds to (180 deg).So a 2.5% duty cycle to 12.5% duty cycle is the range.The photo depicts 1ms(0 deg) to 4ms(180 deg) as the range which is not correct.All 4 worked normally and were able to traverse 0 to 180 degrees.They are not high end servos but for the price they work fine.
Rob
2025-07-18 11:53:07
I'm putting these in a "Crystal Cub" which is an interesting project plane built from foam board. Smart people use a laser to cut out the foam in minutes, but Noooo, I had to go old school and use an Exacto knife. Took forever. But I'm in the "figure out the electronics and control hardware" phase. These little servos seem to be a good fit, but I might have actually wanted to use one size smaller. Time will tell if these have way too much torque or are just right. I'll post pictures next review when it's closer to being done. (Remember, Done is a four letter word...)
Napoleon Banzuela
2025-07-05 12:30:39
project worthy
danish
2025-07-03 12:53:44
These servos are great for the price. i somehow actually was given 8, but I guess i'll take it. so far ther have been no problems at all, and the cables are long as well.
Jerry Rutherford
2025-04-14 19:09:48
I needed some small servos for a robotics project... these were not expensive, yet very accurate, quiet, and had more than enough power for my needs. Great product.
Tony B
2025-02-02 15:15:37
Purchased to use in a deerc RC boat. The plug included didn’t match but the leads where nice and long so I was able to solder the old plug onto this servo.Works as expected and now I have a few extra when/if this one fails
John
2024-11-29 15:02:34
They were very inexpensive and they mostly work. The downside is that one was dead out of the box, no movement whatsoever, and another one fails intermittently. My plane flipped over and dived into the ground twice before I noticed that one of these servos was occasionally failing to move. I think the gears were binding, because I couldn’t even move it by hand.The short version is that I wouldn’t recommend these in anything that flies, but they’re very inexpensive so I would totally use them in small robotics experiments or something. Just figure that a couple of them are probably going to be bad.Update: A third one failed today. This one was in my elevator so I was able to bring it back in. As soon as it landed it started working again. I then flew again and the same thing happened. After a couple minutes in the air the elevator servo stopped working and after I landed it started working again. I’m pretty sure the gears are binding and a little jolt from landing frees it up.
Recommended Products
$13.99
$ 7 .99 $7.99