Your cart is empty.
Your cart is empty. The SG90 has 3 wire interfaces in which the connections should be made as follows: Red wire-5V, Brown Wire-Ground, Yellow wire-digital pin 9.
Operating speed: 0.12second/ 60degree ( 4.8V no load) ; 0.10 seconds / 60 degrees (6.0 V)
Stall Torque (4.8V): 17.5oz /in (1kg/cm)
Operating voltage: 3.0V~ 6V
Temperature range: -30 to +60
Dead band width: 7usec
No Load Running Speed: 0.09±0.01 sec/60° at 4.8V Rotary Angle: 180°
9G micro servo motor for rc robot, robot arm, helicopter airplane, car, boat remote controls experiments.
Package Include:
5 X SG90 servo motor
5 X servo arms and screws kit
Thanhlyn
2025-08-09 17:15:07
The servos work well as advertised and intended, although the screw heads aren't the same size. Sometimes it's Philips1 sometimes it's Phililps0, just keep that in mind and have those screwdrivers on hand.
Sasha de Almagro
2025-07-27 10:40:05
These work well for what they are. All 5 that I received were working.
peter20201
2025-06-28 18:34:36
The media could not be loaded.
Willy_HSV
2025-06-21 18:23:27
Nice servo for building your own 3d printer bed level probe. It fit perfectly in the print found on instructables. I did have one go out on me and needed replaced, but that may have been from my experiments while building the probe and having the servo run past the hard stops on the probe. But you get 5 so there is room for error :)
Sarah
2025-06-12 19:57:40
sensitive and fast
B.McMahon
2025-05-17 18:50:20
I bought 8 … 7 of them do not function. Although I did watch one go poof after being plugged into a PCA9865 servo board at 5 volts . They were internally bound up on arrival, they either can’t free themselves or die trying. Save yourself the headache and buy something of better quality, maybe you could run one directly from an Audrino but that’s about it. These are cheap, cheap price, cheaply built. I would not recommend
Alex Gunn
2025-05-14 13:54:58
Excellent SG90, works as intended. Not really a lot more to say. If you don't have a spare few of these in your electronics draw you should probably stock up now.
Skybbles
2025-03-18 17:34:14
I bought these motors as a pen lift for my homemade CNC plotter. Out of the five, only two work. Two burned out, one has so much play that it jitters all the time, and one has a faulty chip that draws too much current and gets extremely hot.I do not recommend getting these motors, but 5 for $10... you get what you pay for.
Abdulrahman
2025-03-10 15:02:54
شغال بدون مشاكل
سليمان
2025-02-24 12:48:42
لا يعمل كويس يل٠Ùقط 50 درجة Ùˆ يعلق
Nora
2025-02-11 12:19:45
السيرÙÙˆ سيئ جدا Øين Ù…Øاولة رÙع Ø¬Ù†Ø§Ø Ø§Ù„Ø·Ø§Ø¦Ø±Ø© يعجز ويخرج اصوات لا Ø§Ù†ØµØ Ø¨Ù‡
Recommended Products
