Your cart is empty.
Your cart is empty.Product Description
50 Amp Generator Power Inlet Box
Replacement for NEMA SS 2-50P PB50 125/250 Volt 12500 Watts Generator Transfer Switch ETL Listed（3 Prong）
Kind tips
It is recommended to use a step drill on the threads, and the housing can be disassembled before entering to facilitate the fixation of the rear housing and provide enough space for wiring design.
Design:
The product is designed with locking holes, and you can add locks as needed to enhance security. Whether installed in a garage, yard, or campsite, you don't have to worry about electricity theft or malicious power outages.
You can connect the SS2-50P connector as follows:
1. Connect the live wires of the terminals marked with "X" and "Y".
2. Connect the neutral wire to the terminal marked with "W".
3. Connect the green ground wire to the grounding terminal inside the cabinet.
Safe & Reliable Electric Inlet Box
Phillip Hiles
2025-08-21 20:57:45
I like this outlet because it has allen head lugs and metal knock out the other boxes comes with plastic pop in plugs which allows water and bugs to enter easily
N.
2025-05-27 11:34:15
I added this box to a little cabin so that we can run it off a generator with a simple plug-in. I probably could have gotten away with a 30amp inlet, but by going with the 50amp, it should allow for a decent amount of future draw without needing to redo the whole box. The box is pretty heavy duty and I like the fact that it has a weatherproof seal so that it protects the contacts for the 99% of the time it is sitting unused.
Customer
2025-04-14 17:31:07
The housing punch outs were not done well. I had to cut them out and it bent the box
reviewer33
2025-02-11 14:44:10
This inlet box is solid and works well. Similar to others on the market. It is solid metal and should be hold up to normal weather conditions. Where the box falls short are the knockouts. They are mainly for looks rather than function. You can't really knock them out with out a special knockout tool or a drill. I was not able to remove them using a standard screwdriver and hammer like you can do with many knockouts. On the plus side, give this will be exposed to weather, the knockouts are less likely to leak. Connecting 10 awg wire is difficult given the tight space inside the box, but no different than other inlet boxes.
Recommended Products