Your cart is empty.
Your cart is empty.ACDelco GM Original Equipment Pigtail Connectors are connectors ready to be spliced into vehicle harnesses, and are GM-recommended replacements for your vehicle’s original components. These original equipment pigtail connectors have been manufactured to fit your GM vehicle, providing the same performance, durability, and service life you expect from General Motors.
Deborah Mercer
2025-06-20 15:03:29
This fit my 2001 Chevy Silverado manifold absolute pressure sensor perfectly. I had ordered one previously that said it fit and when I received it, it did not. So I was kind of skeptical and was going to go to the auto parts store locally and pay $50 for one, but decided to give Amazon one more try because it was so much cheaper. I received this in the mail and it fit perfectly!
WHBC
2025-06-11 14:24:41
Pigtail for the MAP sensor would have been easier to install if the older wire I was attempting to attach to did not keep breaking on me. I installed it, but I am still reading a low voltage map sensor reading. maybe it is the scanner I have, but I do not know as it is intermittent, but this is an OEM part nonetheless
Ed Lowery
2025-06-07 11:59:56
this product allows the DIY to repair a bad connection back to factory level quality.
dkorrie
2025-05-28 13:35:56
I got this part for my '97 Tahoe. It says it is for this vehicle. I double checked that just now. It arrived with the packaging intact but the wires were broken. It looks like someone dropped something sharp on the wires because all 3 of them have a large ding in the insulation that goes all the way to the wire itself. However, even the plastic bag the part is in is not damaged, so the damage had to be before it was put in the plastic bag. Since there was some undamaged wire left on the connector, I cut the bad part off and spliced it in with the shorter wires. They I went to plug it into the crank sensor and it would not plug in. The connector LOOKS the same, but upon closer scrutiny I found that the key is on the wrong side! This is NOT for my car, or it is manufactured wrong. I WENT THROUGH ALL THIS WORK FOR NOTHING! Now I had to cut the wires on my car's wiring harness even shorter to put the old connector back on and once I get a good connector I will have to cut them yet again!
Customer
2025-05-13 16:07:29
Great.
john q
2025-04-23 15:24:31
Fit map sensor 1999 mercruiser 7.4 mpi
WTFmyrick
2025-04-10 15:33:09
Looking at the connector from the terminal side, if the alignment slot is on the left side and the large rectangle hole is between the two right side connectors, it's for a crankshaft position sensor. If it's the other way around then it's a camshaft position sensor.
Malcolm M.
2025-03-27 20:12:07
Did not fit 1998 Chevy Silverado had to buy another brand
Cliente de
2025-02-14 11:19:05
Quedó a la perfección, pude arreglar mi problema
Recommended Products
