Your cart is empty.
Your cart is empty.Poorbeaners
2025-07-15 17:45:30
Great product! Works great! Look cool! Wish they made the knob in black but other than that quality product!
Josh Leiby
2025-06-03 20:27:14
I always lean towards quality products even if they cost a premium if the premium is worth it. Though this is just a handle keeper, it is a solid quality build and with the powder coat finish should last the life of the jack or longer. As you can see from the photo, to deal with the rattle issue some have noted with this product (depending on how you have the jack mounted), I just prepped the surface with rubbing alcohol to remove grease or body oils, and added small strips of 3M soft foam tape and when I ran out of that I used some black electrical tape. Problem solved! This not only stops the rattle completely, but protects the powder-coat finish from scratching. I even added tiny strips of electrical tape around the hole for the lock. Basically any surface that might make contact with another metal surface I covered. So with this easy fix, why spend on a bit of rubber that doesn't lock, is ill-fitting, and has to slide off instead of opening?
Thaddeus F Jameson
2025-05-28 13:14:55
In the past I've used the rubber or polyurethane Hi-lift jack handle mounts. They deteriorate over time and in this application the jack was mounted with the handle down so I wanted something that would 100% prevent the handle from coming loose. It works perfect. It's well made even has a provision for a small lock. I've seen some comments that it would rattle. I am using this on my 1971 Land Rover Series 2A so this isn't a factor, the vehicle is one big rattle.
Aric
2025-04-13 18:46:33
I like it but it doesn’t grip the handle tight enough to keep it from rattling. It may just be my OCD but I do not like things to rattle while on the trail or anywhere for that matter.I wish they made it fit a bit tighter.It did not come with the tabs bent like I have in the photos, I personally bent the tabs outward from each other just slightly in order to get the clamp to fit snugger to prevent some rattling from occurring. Seems to work okay to keep it from rattling around too much but I wish they accounted for this and built them to be reinforced on the tabs and thicker to lock the handle in place without any movement.
Mark
2025-03-17 09:03:23
Works good I’d buy again
Mark Welliver
2025-03-03 16:17:15
This is one of those things that you didn’t know you needed it until you have it! After my polyurethane hi-lift handle holder cracked and fell apart I went looking for a new one and came across this item.. I’m so glad I decided to buy one of these instead of what I had! This is heavy duty, has a very nice finish and fitment and best of all it’s made here in the USA!
jason lewis
2025-01-29 18:39:15
The media could not be loaded.
Rlw
2025-01-25 15:28:02
Installed on farm Jack for Jeep. Holds it together well even through trail rides! Easy to install. Seems to be heavy enough to withstand weather conditions.
Jean-Philippe S.
2024-12-12 20:41:13
I guess you pay for quality but that's just so expensive. I really needed it to stop the pole from shaking so still a good purshase
Recommended Products