Shopping Cart

Your cart is empty.

Your cart is empty.

Alinan 8pcs 2CH Optocoupler PC817 2 Channel Isolation Board Voltage Converter Adapter Module 3.6-30V Driver Photoelectric Isolated Module

5.0 (6) Write Review
Free shipping on orders over $29.99

$9.99

$ 4 .99 $4.99

In Stock

About this item

  • ★Driving Port Signal Voltage: 3.6-24V; Output Port Voltage Port: 3.6-30V
  • ★Can realize 3.3V or 5V to control the interface of 3.6-30V voltage . After the control terminal is turned on, the controlled terminal will also be turned on.
  • ★Photoelectric isolation has strong anti-interference ability. Can drive big behindPower triodes, MOS tubes, etc., where high voltage driving is required, can also directly drive low power 24V relays.
  • ★If it is a pulse signal, please note that the limit of 817 is below 4KHZ. If the control signal is greater than 4KHZ, please do not use this module, it will not work properly.
  • ★Through the jumper cap can achieve whether the output is high potential output or low output.The 2th and 817 on the board are independent, which can realize simultaneous control of different voltages, etc.


Feature:
Item Type: 2-way Voltage Isolation Board
Material: ABS
Guide Gate Signal Voltage: 3.6-24V
Output Port Voltage Port: 3.6-30V
The jumper can reach the exit gate: high potential or pull the exit pad


Neil
2025-07-30 16:59:59
At least 1/2 of 1unit
Customer
2025-06-20 12:27:59
This doesn't work at 3.6v and barely works at 5v. Works at 12v.
Mike
2025-05-07 17:13:31
No output signal connector is added to the PCB.
Neil
2025-02-15 12:34:27
At least 1/2 of 1unit
Customer
2025-02-13 15:26:35
This doesn't work at 3.6v and barely works at 5v. Works at 12v.
Mike
2025-01-28 15:34:46
No output signal connector is added to the PCB.