Shopping Cart

Your cart is empty.

Your cart is empty.

Amana Tool - 45838 Carbide Tipped Dovetail 7 Deg x 17/32 Dia x 25/32 x 1/2' Shank

Free shipping on orders over $29.99

$20.48

$ 8 .99 $8.99

In Stock
  • Diameter (D) 17/32
  • Angle (a°) 7°
  • Cutting height (B) 25/32
  • Shank (D) 1/2
  • Overall length (L) 2-3/16


For the Keller Dovetail templates and certain Incra applications, 7° dovetail bits are required. (Bits for the Keller system are supplied with shank-mounted bearings.) this angle is also used in cutting Stair stringers., #45838, diameter (D) 17/32, angle (a°) 7°, cutting Height (B) 25/32, shank (D) 1/2, overall length (L) 2-3/16, Type Porter cable jig 4210 & 4212, flutes 2, Carbide Tipped Dovetail 7 deg X 17/32 dia x 25/32 x 1/2 inch Shank


DMK
2025-09-02 10:58:15
I was going to use dovetails for 28 small drawers I was building for 4 tool boxes, but after an initial trial, I decided on using 1/4" finger(box) joints instead due to the very small pins that the jig left for the joints.The bit worked fine, however.
Fisch sticks
2025-08-08 14:24:53
Great bit stays sharp lasts longer than most brands
Moose Woodworking
2025-06-24 19:57:01
This bit works perfectly with a Freud 5/32" straight bit for milling miniature dovetails using the template for the PC 4212 dovetail jig. Be aware that the bits required for the miniature dovetail template that Porter-Cable lists in their operators manual for the PC-4212 jig are not available.
Kevin F.
2025-06-14 16:35:30
If you are looking at this you probably own the porter cable dovetail jig and need a replacement bit for the mirco dove tails. DO NOT BUY THIS ONE. After the porter cable bit got dull I got one of these, I broke 6 while trying to make 10 drawer boxes. The head is brazed on and the head breaks as exactly the braze point.
Chet
2025-06-03 11:47:06
Better than most brands. I prefer Amana brand because of selection and durability if properly used.
Jim Short
2025-05-13 11:20:43
Nice blade, stays sharp and clean
Willy H
2025-04-26 18:15:08
I used this bit today. I have to say I am pleased with the performance. Clean sharp cuts.
Richard Bazan
2025-03-30 10:36:57
Cuts well, I use it when I make drawers
Ted
2025-03-01 11:30:42
Can tolerate heat better than the non carbide tipped versions. Sliding dovetails torture these small bits.
Pat Downs
2025-02-04 18:36:20
No problems