Your cart is empty.
Your cart is empty.Product Description
Wrist strap tester verifies that resistance of your wrist strap is no lower than 800KΩ and no greater than 11MΩ.The proper resistance will provide an "OK" GREEN LED indication on the wrist strap tester. If either the RED "FAIL LOW" or YELLOW "FAIL HIGH" LED's light, and the audible indicator sounds, then the wrist strap (or the ground cord) should be replaced.
Outside size: 80(W)x40(H)x117(D)mm;
Weight:145g.
LED and Audio Results
Quickly check grounding straps with push of button. Connect grounding cable end to wrist strap tester and press the test button. Results will be indicated with Visual LED and Audio beep.
ESD Safe and Portable Design
Smooth edges around, ESD safe, essential for your electronic and welding workstations. Used for factory calibrated and quality control checked.
The static strap function, Wrist Strap Tester can quickly and easily check the following:
Test static strap and ground wire connection
Test the impedance between skin and Static strap
Test the connection during anti-static access panels, cushion for connecting ground
Quickly and easily check ground systems at any place
Avoid static electricity discharge damage to product
Ensure staff safety
LO (red): R<800K ohm Buzzer Indicator: ON
OK (green): R = 800KΩ ≈ 11MΩ Buzzer Indicator: OFF
HI (yellow): R>11M ohm Buzzer Indicator: ON
Dimensions: 80(W)x40(H)x117(D)mm
Power source: 9V battery
natevw
2025-02-11 20:19:26
The media could not be loaded.
Recommended Products
$2,480.00
$ 99 .00 $99.00