Your cart is empty.
Your cart is empty.AP Products' Equalizers come with pre-installed Nylon bushings. The EQ-104 assembly features a 5.75 inch length by 2 inch width by 0.5625 inch diameter. Built with quality materials
Geoff Harris
2025-06-07 18:30:52
casting was good, fit was good
Leo
2025-02-13 10:23:48
These stabilizers are well build, come with a very rugged sleeve and match up to OEM perfectly. Just rember, the shackles go "up" when you install them.In otherwords, the spring mounting holes go above the two stabilizer holes to form a "W" when installed. (The frame hole goes to the middle mount, the two spring mount holes should lay even at the bottom parallel to the ground, and the shackles should bolt in a manner that the bolts from the leaf springs are mounted to the springs so that the leaf springs sit ABOVE the lower two leaf spring mounting holes. --°•♤•/°-- **The levelers should never sit "up" or "down" in the front or back while off the ground or on a flat surface.** Also, both sides HAVE to be replaced at the same time or you're just wasting a lot of work time that's otherwise easy and quick to do if done right the first time. One side could "look" fine but a bad bushingthats 1/16th of an inch off on the left could equal a 4 inch difference of where the tires sit on the other, opposite side of the axles with the new part making you think the new part (if only one is replaced) is bad when it's just not worn the same as the other side. Not worth the problems and tire wear for the few bucks and few minutes it takes to replace both sides. (Since you have the tandems off the ground already)
Recommended Products
