Your cart is empty.
Your cart is empty.Terry
2025-08-06 10:39:36
I installed one of these Rocker Switches on my Commercial Carpet Extractor. Works like the original. Thank you!!
Mary Humphries
2025-07-25 17:09:23
I have a heat press machine and the on off switched burned out. This left me dead in the water with making items. The order was shipped extremely fast and the the switch was easy to install. All I had to do was slide off wire and push bad switch out the push new one in and reattach wires. From start to finish less then 5 minutes.
Sally Crank
2025-06-13 10:44:33
Worked perfectly!
Pawsandreviews
2025-06-03 19:51:54
Good quality
choco
2025-05-07 11:43:10
I bought a chocolate melter here back in 2020. See attached photo. About 2 weeks ago when I would flip the power switch and nothing would happen. If I played with the switch I could get it to stay on but that told me the contacts were bad and electrical fires are the number one cause of fires in the US.So I stopped using the melter until this replacement switch came in. Exact replacement for no name made in China melter.Hope this helps someone out there.
Patricia L. Quinn
2025-04-30 15:25:08
The switches are very sturdy, have great action, and fit the panel cutout for my UTV like a glove. Was able to quickly repair and get back into operation with these.
l'Uomino
2025-03-01 10:43:19
I replaced a very old toggle switch in an electronic circuit with one of these switches, which was switching 120 VAC at 15A max. After installation but before loading, all checked out. However, the first time I powered up the equipment, the switch shorted on. (There may have been an initial surge current, but the surge was sufficiently brief that it blew neither the 15A breaker nor the 20A in-line fuse.)I then replaced the switch, and again tested prior to initial power up. Again all was well at this point. However, once again upon initial loading, the switch shorted on. Disassembly of the first switch confirmed that the contacts had fused.They might be ok for a 10A or less load, but I've not confirmed this supposition.
J. Flaherty
2025-02-05 17:14:26
I got these switches in September, it is November and I've had one fail on our coffee maker. The amperage and everything is the same as the old switch, but maybe just a quality control issue? My wife is running a coffee maker and it started to smoke. I've got another one, going to try it too. We'll see if I get 2 months out of it.
Recommended Products