Your cart is empty.
Your cart is empty.Product Description
Made of high quality 45# steel + rubber material, durable, anti-corrision, lightweight, longtime to use, easy to operate.
Install CV joint boot without removing drive shafts from the vehicle or the CV joint from the drive shaft, high effect, time and energy saving.
The CV joint boot installation tool is easy to use, just lubricate the boot and place it on the expander finger to activate the air valve, expand it and place it on the joint and release it.
Features:
Made of sturdy material for greater durability, which can maintain tool Kit stability in every high-intensity job.
This CV boot fitting tool is designed for stretching flexible CV boots onto the drive shaft assemblies without the need to remove the CV joint.
Simple single-button operation expands the CV boot in seconds to fit over the CV joint, save on labour time by up to 70 percent and prevent damage to CV joint. Suitable for cars and light commercial vans.
Note：When installing the air hose nipple, remember to use the PTFE tape, ensure that the joint is tightened to avoid air leakage.
Package Included:
- 1 x CV Joint Boot Installation Tool
- 2 x 1/4" NPT air hose nipple
- 4 x Black O ring
Hunter Odeneal
2025-08-16 13:34:19
It doesn't expand as far as it says on the listing. Not to mention the boot doesn't stay on the tool while using it. Would not recommend. It is GARBAGE. If i could leave zero stars i would 0/10
Tucker
2025-08-03 17:07:03
Make sure your CV joint I small, I have a 2010 Ram 1500 and it absolutely did not spread the boot enough to install it. Luckily my CV is easy to disassemble and I just bit the bullet and did that. I should have just done that in the first. I may never use this tool again and I feel like I wasted my money. I had 120psi on the wall and even tried warming the boot to no avail. Either buy new CV axles, or learn to disassemble, you need to clean the old grease out anyway before you apply new as per most CV boot installation instructions. I'm sure this tool is good for small cars and quick emergencies, do it right and better if you can without the use of this tool.
Branden Lee Sandoval
2025-06-19 14:48:49
Got the job done, just barley opened up enough to force the boot to slide on
Bamazon
2025-04-29 10:13:25
how do I get in contact with the seller? this tool is defective. it won't spread the boot. this boot i have is designed to work with this tool. it's definitely not the boot. I'm running my compressor at 110 PSI. the tool has a hissing noise at approximately 70 psi. is there something I'm missing here? am I supposed to adjust the inner valve or something? please contact me.
MAURICIO
2025-03-20 14:57:35
Salió defectuoso
Randy
2025-03-09 12:58:04
Still trying to figure out how to use it build well
Braeden
2025-01-19 13:45:45
Well for starters it’s supposed to have a 5.5-6†spread from my understanding. Not 4â€. I wouldn’t have bought it if it was. I read the description and info on it, shows photos of the spread and it is obviously advertised falsely. It’s quite upsetting and frustrating as I had to wait for the tool and now I have to push my schedule back on this when I’m already in a time crunch.
Jose Cabral
2024-12-19 16:58:29
Doesn't have enough force to open a boot meant to be used with a cone style tool...not even at 150psi
Recommended Products