Your cart is empty.
Your cart is empty.3-Way Passive Crossover CRX-303 Brand: Audiopipe Gold Plated Screw Terminals 300 Watts Max Power Impedance: 4 Ohm High Grade Polymer Capacitors Ferrite and Air Cooled Spools Crossover Woofer Frequency: 20Hz~316Hz Crossover Midrange Frequency: 700Hz~4kHz Crossover Tweeter Frequency: 1.5kHz~20kHz Dimensions: 4.875" L x 1.375" H x 3.75" W Quantity: 1 Piece
Fridge42o
2025-08-25 16:55:48
Well built, look fantastic, my only complaint stems from a misdoing of my own. These crossovers are meant for 4 ohm speakers. If you put a speaker that is anything but 4 ohms, it pops and crackles beyond a certain voltage. I bought these to split up the full range signal from my Nobsound 2.0 2 channel amplifier that I use on my computer. I have tweeters, mids, and subs for it, and when they're all hooked up to the amp straight, giving each a full range signal, (tweeters have bass blockers) it sounds amazing until it's cranked to full blast (before the distortion point of the amplifier) at which point I begin to hear fuzziness from my mids trying to play bass, which the speakers do not even attempt to do, instead getting really fuzzy on bass notes.Anywho.... Back to the point. My tweeters are 4 Ohm, my mids are 8 ohm, and my subs are 6 ohms. Needless to say this created problems when I hooked them all up to the crossover. The mids sounded like garbage at even a low-decent listening volume. When cranked to proper listening volume everything sounded like garbage, completely unacceptably bad. Before I decided to get disappointed with my new crossovers, I decided to do some testing.I unhooked everything from the amplifier and test-rigged the crossovers with a JL JX400/4D amplifier and some 4 ohm 2015 stock Impala speakers and a 4 ohm SSL 12" sub and everything sounded beautiful all the way cranked up. These crossovers rock!! Highly recommended. They're really huge, perhaps only a problem if you plan on hiding them. I myself plan on installing LEDs in them and putting them on display in a friends car, wired up and fired up to some extra rear deck speakers.
Paul A. Schuster
2025-07-26 21:54:29
received two, one was in an unopened package, the other was not. the one that came in an open package was missing the four screws that hold the transparent cover over the electronics/housing. the unit in the unopened package had its four screws in place. I robbed two screws from it and applied them to the unit that was missing all its screws.I will say that the sound of my speaker box project was notably better after adding the crossover. it's not small and quite hefty. no complaints about the guts and build quality.
Zoomin
2025-07-21 12:33:07
For the price, it’s tough to beat.
andrew blackmer
2025-07-12 15:03:07
These crossovers sound great. Unfortunately they fall apart. One arrived doa. They replaced it immediately. New one fell apart shortly after. Fixed with zip ties. Drill holes and secure them to the circuit board.
Farid Jamal
2025-07-02 14:02:06
After trying several crossovers for my Cerwin Vega component speakers I decided to give these a try. Simply put, it was like lifting curtains off from the speakers. All frequencies are crystal clear, especially compared to the OL 3-Way frequency divider (4-8Ohms) which was complete trash. The components used are of good quality and that is evident from the sound reproduction.
pedro
2025-05-23 15:07:18
5 miutos empeso a echar humo lo desconecte y no buelvo a poner otro de estos ala mejor fue mi culpa o defecto de fabrica empeso muy bien pero echo humo.
Brandy B.
2025-05-03 13:16:14
This thing is absolutely garbage its missing about 400 frequencies between sub and mid a crossover should be 20-500 200-4000 2000-20000 or 20-500 500-4000 4000-20000 both are good but the first is better though so this thing is absolutely garbage I attached pics this one has 20-316 700-4000 1.5k to 20k so notice between the sub and mid its missing a lot believe me its very noticeable I have dayton audio point sources and tweeters and a sub and they sound terrible with this but better without bottom line please dont get this they lied about everything about it looks nice feels nice sounds terrible and is cheap if u put this in a portable bt speaker get ready for it to sound like trash id love to have a refund but it cost money that they should have to pay im going to look for a better one im not blaming audio pipe the seller misled me but they do need to fix that gap really bad so dont buy from this seller and dont but this crossover both are terrible
Diego Gonzalez
2025-04-09 12:06:46
Pretty good cross over, I ordered it to replace a crossover I had broken. The only thing that I didn’t like about it was that it’s a bit bulky, other than that it’s pretty good quality/sound.
Rafael Hernández
2025-03-31 15:49:23
SON EXCELENTES
giacomo
2025-03-27 14:33:21
Wired two 8ohm goldwood sound tweeters in parallel to augment into 4ohms paired with a 120w 4ohm goldwood sound midrange and a 180w 4ohm 6 1/2 inch goldwood sound woofer. Sounds incredible in conjunction with the crossover.
Ganesh mahato
2025-03-16 17:55:30
This product is very good and suouds quility are very smoothly..... i am satisfied this product
Oswar Javier Lizarraga uzeta
2025-01-09 13:48:25
Muy bueno funciona muy bien
WICK1974
2024-12-06 19:05:15
Not many choices for 3-way crossovers .. these will do donkey 🤣
Recommended Products
