Your cart is empty.
Your cart is empty.
BIGTREETECH TMC5160T Pro is a high-performance stepper motor control chip that operates via an externally enhanced power MOSET has it, the maximum current can reach 20 A, low heat development during operation.
Driver Chip：TMC56160-TA
Product Dimensions：15.3 x 20.4mm
Power Supply Voltage(VM):8-56V(Recommended voltage：12V,24V.36V,48V.56V)
Maximum Microstepping: 256
Operating Modes: SPI,SD
Dawne Short-Scott
2025-08-22 17:50:23
So I purchased these with the assumption that I could easily enable SDI mode but they come shipped in both SPI mode and SD mode enabled. I have attached a picture of what has to be done if you purchase these to use in SPI mode only so you will know what has to be done. Basically you are removing one tiny resistor and bridging across two small pads. I don't recommend doing this unless you own a digital microsoft but it was fairly easy to do.
Wood Slicer
2025-08-12 10:45:40
Makes my 3d printer go VROOOOMMM!!! Solid product but only software spi support on the Manta M8P.
Brian Gunderson
2025-08-09 16:07:25
Be prepared to triple check if your machine is actually moving. These things are accurate and SILENT.
kenneth rood
2025-06-25 18:41:45
did not ft thre M8P board as indicated
Customer
2025-06-01 16:55:10
These work well in my Spider v2.2 board running at 48V with LDO motors. This will be my goto stepper driver for all future builds involving 48V
Isaiah
2025-05-16 10:03:53
My 330x330 machine can move incredibly fast with these at 48v
Joseph R Meier
2025-04-04 14:19:47
Horrible QC. ordered 2 sets of 2. One driver came dead. Returned the two pack to Amazon and received two more. One of which immediately failed. Will be returning all of them now as I can’t trust them in a production machine.
Goran M.
2024-11-23 14:55:32
They work great. Got the hooked up to 48v on my x and y steppers on my Voron 2.4.
Recommended Products
