Your cart is empty.
Your cart is empty.Bus Kote is a high-build, 100% acrylic, elastomeric roof coating, which is UV and weather resistant and is fortified with Hy-Tech’s ThermaCels. Bus Kote, with its bright white formula, is designed to insulate, seal, waterproof, soundproof and protect with a thick rubber-like, ceramic reinforced shield that expands and contracts with varying temperatures, as well as resisting thermal shock. Bus Kote was originally designed as an insulating, reflective coating for school districts to use on the roofs of school buses to lower the interior temperature. This energy saving coating will reduce interior temperatures when hot due to Hy-Tech’s ThermaCels. Formulated to resist over 100 m.p.h. wind driven rains, the coating resists damage by hail and rain, and insulates against noise and their corrosive effects. Surface Preparation: Surfaces must be clean and free of dirt, grease, excess chalk, loose or scaling paint. Paint will not stick to a chalky surface. Glossy surfaces need to be dulled by sanding. If taping off areas be sure to remove tape with each coat while the paint is still wet. Primer: Aluminum and galvanized metal, fiberglass, rubber and pre-painted surfaces: Aqua Prime #15 Rusted metal: Clean, wire brush and apply one coat of rust converter followed by one coat #18 Metal Prime or #15 Aqua Prime. Joints, Seams and Cracks: Apply one coat of Hy-Tech Elasto-Patch, elastomeric patching compound to all horizontal or vertical seams. Application: Stir thoroughly before use. Apply 2 full generous coats by brush, roller or spray gun. Roller: ¾”-1-1/2” nap depending on surface texture. Spray: Remove all filters, use a tip size of .024-.035 First coat should be allowed to dry overnight before applying the second coat. Do not thin or add other paints or solvents. KEEP FROM FREEZING Do not apply when temperatures are below 50°F. Coatings should only be applied when ventilation is adequate.