Your cart is empty.
Your cart is empty. The CanaKit 3.5A USB-C power supply (UL Listed) is specially designed and tested for the Raspberry Pi 4. This CanaKit power supply incorporates a noise filter to provide the highest power stability. It incorporates a thick 18 AWG and well insulated cable with a 5-foot cable length.
Important Note
Compatible with Raspberry Pi 4 only. Not compatible with Raspberry Pi 3 B, B+, A+ or Pi Zero.
Deedle
2025-08-31 10:30:58
It was easy to put together. Handled the heat well. Compatible with raspberry pie 4. Functioned as described. Build solid. Would buy again.
Darin D & Kelli D
2025-08-28 14:11:14
I've tried multiple power solutions for my Raspberries but none give the results of individual power supplies designed specifically for the task. I run four Pis in a UCTRONICS rack mount, each with an SSD drive rather than Micro SD cards. This power supply runs everything I throw at the Pis and never throttles. The 'vcgencmd get_throttled" command always returns "throttled=0x0" regardless of load when using this power supply. Other power supplies and multi-port USB chargers will return other throttled statuses including "throttled=0x500000" which indicates throttling due to undercurrent.My only nitpicks with these chargers are:1) The cables are very stiff and hard to route neatly into my rack mount2) The magnet at the USB end of the cable is very large and interferes with cable routing as well3) The cables are permanently attached to the brick and can't be replaced in case of a short, etc.I highly recommend this power supply and have bought four of them so far and will continue to do so as I expand my Pi fleet. I do wish they would offer a larger power supply that could run multiple Pis to eliminate all the redundant wall bricks.
Mark Vaughan
2025-08-23 13:34:52
Great power supply and USB charger.It was originally bought in 2020 to power a Raspberry Pi 4, but has seen a lot of extra use as a USB-C charger, because the output is up to 3.5A.It is shown in the pic charging a Playstation 5 controller, just one typical example use.The CanaKit power supply is silent to my ears, with no troublesome high pitched whine or any switching noise. Build quality is great, the plastics are solid and the connector itself is also of high quality.It's built well and has stood the test of time. A recommended purchase!
Drew
2025-08-19 18:09:18
Works well for powering my PI, cord length is a good size for what i use it for. Seems durable and its a power cable that is easy to use. Is compatible with other Usb devices as well.
CF
2025-08-15 18:06:25
It does what it is supposed to do; the PI does not suffer power undervoltage even when overclocked; but there is a large flaw which is that the power supply has no switch; so you plug it in and the PI goes on and stay on until you unplug it.You can solve the issue by adding a switch between the power supply and the pi; but feels like the switch should be on the cable already
Scott
2025-08-07 11:21:25
I needed a new power supply for my Raspberry PI, this did the trick!
Brian R.
2025-07-02 13:29:49
I'm running two of these each powering a Raspberry Pi 4B 8GB in an Argon One case (hence supporting the accessory board and M2 SSD) as well as various USB accessories. Each are running perfectly with no power issues.You may think your Raspberry Pi is running ok with that "rando" USB charger you grabbed out of a drawer but it may be silently screaming. Here is a quick command you can issue that will indicate if your board has detected an undervolt since power-on or return "ok" if not:dmesg | grep -iC 3 "undervoltage detected" || echo "ok"
JThayer
2025-06-28 10:12:51
It took me a few months to finally get a Raspberry Pi 4 without paying a premium price but now that I have it, I need to power it. This power supply is perfect. Not a lot to say about it other than: Plug it in and it works. If I had anything more to say about it, it would be negative and since I don't have anything negative to say, this review is done.
HiFi Joe
2025-05-03 16:14:47
Comes with a fixed flat 2-pin type plug, no idea what country that is for, and not a UK 3-pin plug and no adapter supplied, so useless for me after waiting weeks for delivery. Doesn't mention plug type at all in product details.
Byn
2025-04-13 10:18:04
No sirve el amperaje reseñado.Devolución imposible por no ser gestionado por Amazon.
Niels Heinze
2025-01-28 16:39:13
Für D nicht zu gebrauchen, da es mit US Stecker ausgeliefert wird. Könnte man auch mal dazu schreiben.
Alan Hooper
2024-12-31 16:39:56
It powers my Raspberry Pi 4 with no problem. With a 3 amp PS I kept getting low voltage warnings, with this 3.5 amp unit there is no more warnings.
urugamai
2024-12-15 12:34:21
Suspect the unit is perfect but the item did not list its plug type and so I now have a U.S. only one. bought the right one from another supplier so not held up much.
Recommended Products
