Your cart is empty.
Your cart is empty.Product Description
The hard metal casing
The shell made by metal, reliable and strong.
Easy to install
The red wire connects to the battery 12v+, the yellow wire connects to the power cable of the stereo where the electricity is going. The black wire connects to the vehicle’s metal frame or any available ground wire.
Reduce Audio Noises
Filtering the power supply can reduce noise generated by the cigarette lighter or the other electronics. Get crystal clear sounds from the car speakers.
Capt.Dan
2025-09-04 17:02:21
I don’t know how it works, but it does. I run a mini pre-amp thru my boat stereo to use with a CB style mic as an inexpensive PA system. (Guided sightseeing charter boat).New boat had a ton of line noise when the engine was running. So much, the PA was not usable. I ran the 12v supply for the stereo and pre-amp thru this isolator, and it greatly reduced the noise. There is still some noise, but it went from un-usable to useable.To be fair to the remaining line noise, I have to crank the radio volume to 33-35 so my guests can hear me. That’s pretty high, and I don’t fault this product for not removing 100% at the highest volume.Oh, like others have said, the wire insulation is ridiculously thick, but the wires are maybe 14 gauge, and appear tinned. The thick insulation only makes butt connectors really tight.
Matthew
2025-08-05 16:48:15
This absolutely works if installed correctly. Most of the Dual Electronics stereos have an alternator whine due to cheap or non-existent shielding within the radio itself. This is from my own personal experience with the brand. If your old car stereo did not have an alternator whine, and now it does, and you’re sure it the new stereo was installed correctly, it’s more than likely the build quality of the radio. To completely fix the whining noise, do the following: connect the Power Filter on the yellow, constant-hot (memory) wire between the vehicles harness and the car stereo. The “input†wire connects to the vehicle’s harness, the “output†wire connects to the stereo harness. Ground the black wire to a metal component attached to the vehicle’s frame. ZERO noise is now coming through my speakers when the truck is running. No noise on Bluetooth, AUX, radio, etc. Excellent product!
MisterCD
2025-06-27 19:24:40
The thickness of the insulation is annoying as it makes cleanly adding a connector to it impossible. The internals are not great. Someone did a very poor job with the soldering inside. It also relies on the thickness of the insulation to keep the components from shorting out on the case.The good: it mostly works. As the title says it took away like 80% of the noise. It's not perfect but I have to turn the radio up so loud that if it was playing anything I would never hear the static over what was playing.Really dont like how cheaply it is made. Hope it lasts.
Jubal Harshaw
2025-06-07 10:28:53
I have left very few negative reviews compared to the number of positives. That said: this thing does not work. I got no reduction in noise floor when it was installed. I do see where some have had decent results. This may mean I just got a bad unit. The build quality is not that great when I looked inside. The wire gauge is deceptive as well. In the photo this looks like 8 gauge but is actually closer to 14. As such; current handling capacity is limited.I would go with something different or order the parts and make your own. I am now in the process of either finding a better unit or homebrewing.
Tyler Krajicek
2025-05-30 10:33:00
I was having a very audible static noise in my boat, I replaced every cable, wire, etc I could think of with no luck. I didn’t want to isolate a battery to solely power the radio so opted to try this. The static is slightly down but not completely gone. Overall, it did quiet it down but didn’t fix my issue.
Taylor
2025-04-17 14:15:40
I recently got into big audio with the DSR one it has 258 bands I believe so when I first installed it, it had a really bad alternator. I could hear my fans from every point of the car outside and interior lights you could hear just a whole slew of electricity problems The minute I installed this and turned my car on it went away. I mean you can hear and I mean to the slightest a bit of alternator wine, but it’s not enough if you’re not focused like you really gotta focus on it, but although this thing worked as it was intended. I love it. I would recommend this to anybody that is having car electricity noise problems
ALBERT S.
2025-04-16 16:07:28
It works , perfectly all noise is gone
ssarver
2025-04-13 12:56:29
I have a velex bluetooth amp that I bought from amazon 3 years ago. I isolated the static to the unit and I'm pretty sure it might be going bad. This is in a 1970 Monte Carlo. I figured I'd try this before placing the unit as I know its cheap and probably wouldn't last long. (3 years is good compared to others reviews of the unit). Surprisingly this removed 90% of the static, maybe more. Hoping it will help me limp along a while longer without replacing the unit. I can't hear any noise at all any more, maybe a crackle once in a while but before I installed this line filter it was unusable. Very pleased!
X-T
2025-04-12 15:10:24
The media could not be loaded.
Omid Fatouraee
2025-04-11 11:15:13
Pointless, Did not work at all.
js
2025-03-26 11:35:19
Appears to be well made, works as intended to reduce noise for head unit, no hum or whine and less popping when tuned to AM.
Kenneth St Amand
2025-03-17 16:38:17
This product was installed in a professional manner, and there was 0% accomplished with RFI elimination. Altenator/engine whine and static are present directly after installation. I mean the filter as advertised seems well built, out of metal and not plastic, thick insulation on the wires which is good. And yes as stated, it was installed in a professional manner.
Darcy Benoit
2025-02-03 09:35:48
Works as expected. Power wires were much thicker than I expected. This removed the feedback noise that I was getting on my FM transmitter.
Recommended Products