Your cart is empty.
Your cart is empty.
Specification:
- Quantity: 100 pieces / Pack
- Lens: 5mm Diameter / Transparent / Straw Hat
- Emitting Color: Red Green Blue Slow Flash Automatically
- Luminous Intensity: 2500-3500mcd
- Viewing Angle: 120 Degree
- Forward Voltage / Current: 3V-3.2V | 20mA
- Polarity: Anode (Longer Part) | Cathode (Shorter Part)
Search "chanzon led diode" for more related leds.
Jestin
2025-09-05 18:33:58
THESE LEDS WORK SO GOOD AND HAVE GOOD BRIGHT LIGHTING. THANKS!
Tinana
2025-08-21 13:11:13
Led worked great .
Michael Raphone
2025-08-06 14:31:26
Very pleased with this product.
JonBrawn
2025-07-27 12:58:55
When used with a new button cell these tend to spend more time being white rather than coloured. If the battery runs down a bit then it’s more balanced.
CoffeeDragon
2025-07-03 21:35:00
My daughter and I designed and built a vehicle to safely transport a raw egg through an obstacle course without breaking the egg. When the vehicle was done, she wanted to add a bunch of bling to increase her chances of winning the most creative design category so we found these together and she was pumped. I taught her how to solder a resistor onto each of the LED's and then wire leads onto each leg. After punching holes for each of the lights and gluing them in place, we wired them all in parallel back to a LiPo battery through a TP4056 charge/protection board with an inline switch to turn them on and off. They worked perfectly, bright colors, wide angle with a nice slow cycle rate through RGB. What's nice is if you hook up a bunch of them, they'll all cycle at slightly different speeds so you get a kaleidoscope effect.
Syed Naqvi
2025-05-18 10:55:19
Product performed as expected
Schooner
2025-04-23 12:56:59
Decent 5mm LEDs with slow changing colors - cycle time to go through the three colors is about 15-20 seconds.However, disappointed in total light output from these Chanzon LEDs.The fast flashing 5mm Bluecell LEDs give out much more light at same mA current level.I am comparing to this Bluecell product:https://www.amazon.com/gp/product/B006LUZLNY/
Calibrator54
2025-04-13 16:14:54
These things are super-bright; they operate at 3.0-vdc 20-ma, so a 12vdc, 2-amp source will power upto 100 of these; just series-connect a 470 ohm, 1/4w resistor to each led and power the Anode-side of the all diodes in the circuit and there you have it... excellent illumination source for a camera, microscope, endoscope, etc. Do not exceed 3.2-vdc as measured across the diode; they may burn-out. Also, If using a higher, or lower voltage source, adjust resistor requirements accordingly; use OHM's Law or goto a Web-based calculator for led resistors.To the seller; regarding a misnomerWhen referencing specific elements of such a component, popular terminology need apply. For example; under the caption/statement:"Polarity (3 V) : Anode (Longer Part) | Cathode (Shorter Part)";this passage is a misnomer; these elements are commonly referred to as "Leads" the word "Part" is the misnomer in this case and should be changed to the word "Lead"; it is afterall, what this element is called... thanks
Andreas
2025-04-12 14:27:37
can suggest anything on these, but the set i had before are great.
RMJ
2025-03-20 17:30:53
Die Leds haben genau meinen Vorstellungen entsprochen. Hell, langsam und schnell blinkend im Wechsel.
Antonio
2025-03-13 21:07:49
Come da titolo questi led sono magnifici. Onestamente me ne serviva uno solo per sostituirlo in una stella sulla punta dell'albero di Natale. Con gli altri mi inventerò qualcosa per Natale prossimo.
Rolf Wermelskirchen
2025-03-09 12:39:16
Funktioniert einwandfrei
Peter
2025-02-09 14:29:19
Haben meine Erwartungen erfüllt. Ich habe sie anstatt zu heller LED (weiß) ausgetauscht.
Recommended Products
