Your cart is empty.
Your cart is empty.Product Description
Product Specification:
Shank Diameter: 1/4 inch
Cutting Diameter:1/8 inch
Cutting Length 1/2 inch
Overall Length: 2 inch
Product Specification:
Shank Diameter: 1/4inch
Cutting Diameter:1/4 inch
Cutting Length 1"
Overall Length: 2-1/2 inch
Product Specification:
Shank Diameter: 1/ 2 inch
Cutting Diameter:1-1/4 inch
Cutting Length 1 inch
Overall Length: 3 inch
Public Defender
2025-07-28 18:37:20
I have used this for a 3 hr cut on mdf. It did very well. Not sure how long it will hold up, but is still sharp.
Matthew Callaway
2025-05-28 15:46:33
The media could not be loaded.
Customer
2025-05-18 10:13:16
Clean cutting
Anon123
2025-05-13 15:46:18
This is a lovely bit and I use it when carving 2.5D reliefs in wood.
Brandon
2025-05-11 14:51:42
I use this on a Longmill CNC. I do a lot of 3d objects, and my goto bit is a 1/8 ball. However in areas that don’t have much detail, the 1/8 inch bit is overkill and switching to a larger bit like this for those areas half the amount of time required on a project. I’ve put about 40 hours on this bit so far, and have not noticed any dulling.
Joshua Hankins
2025-05-09 13:58:48
These arrived on time and cut as advertised so far.
Cass Ciegotura
2025-04-25 17:03:37
it is good quality
Brian P Loughnane
2025-03-07 18:30:12
This is the most delicate bit I own, though admittedly I have little experience with small ball-end bits. Still, because of the combination of availability and quality this is my go-to bit for detail carves.
Allen
2024-12-08 15:42:15
Good value.
C & C
2024-12-05 18:08:40
The 1/4 inch shank makes it tough enough for some deep cuts and the bit is sharp. The nano blue coating should help it stay that way for a while too. Works well.
SG
2024-12-01 19:55:01
The Yokishun 1/8" ball nose end mill is fantastic for 2.5D CNC work. With a 1/4" shaft, you're less likely to break a bit, even when doing a full 1/2" deep cut. It's best used for doing finishing work on a relief carving, and the 1/2" cutting length is more than adequate for most jobs. It's cutting as well after several projects as it did fresh out of the package.
TIM F
2024-11-21 16:50:26
Tool feels sharp, coating isn’t easy to scratch off, geometry matches fairly well to description (only a few tenths small in diameter by my standards) and weight is about what it should be from carbide.Having all dimensions listed on the shank is a nice plus if you want to model in a custom geometry tool for simulation purposes.All in all a pretty well made tool it’s hard to tell how it performs after months of use but for now it’s been great.
Recommended Products