Your cart is empty.
Your cart is empty.Product Description
Specification
Input Voltage: 100-240 Volts AC 50/60Hz
Output Voltage: 12V DC
Output Current, Full Load: 5A
Output Power: 60W
Certification: CE, CB, FCC, ROHS
Operating Temperatures: -40 ~ +55degree
Dimensions (LxWxH): 4.5in x 1.8in x 1.2in
Advanced Design
This Intocircuit LED power supply driver is a reliable power source for LED strips and any other devices with power less than 60W and running voltage at 12V (DC).
It's energy efficient which give it another power to run constantly and barely heats up. Its most remarkable merit is Over-load operating, which means it can operate over 60W, but do NOT worry, it's Over-pressure protection and Over-heat protection chipset can protect it from burning out.
Certification
Certification: CE, CB, FCC, ROHS
Full Load Burn-in Test
Exclusive research
Leading technology
Stable and long life
Automatic Protection
Short circuit
Overload
Dustproof
Energy Efficient
Low weight
Small volume
ensure stability
Easy for heat dissipation
Customer
2025-05-29 10:56:14
I think this s a very nicely engineered transformer. Super nice and will install in the back of a double or triple gang "deep" box. I installed it in a triple gang, but knowing, after having installed it, I think it could carefully be installed in a double gang. You can see from my picture.I liked it so much that I have purchased another to use with an inwall amplifier at another location in my house. It's super affordable and seems like it will be perfect for what I needed.
Alex Adamian
2025-03-31 12:22:01
Replaced existing one that stopped working with this one, worked perfectly
jimbo
2025-03-24 17:30:46
The dimensions and size made me think I could mount this supply on a standard metal junction box. But actually the mounting tabs are offset by 1/4 inch. I had to get a plate to close the junction box and then slightly skew the power supply to mount on top.
kedinfo
2025-03-17 11:13:11
I am using this unit to power led undercounter strip. Had to replace other (cheaper) unit that died after 4 months. This one performs as expected. Easy to install. Nice low profile so easy to hide.
Roy C.
2025-03-10 17:57:34
Compact and easy to wire and install.
Customer
2025-02-05 17:20:14
this worked ok to light up the LED lamps, but difficult to direct wire and no ground so found a different one that worked better for my application.
William J. Konietzny
2024-12-31 18:38:44
LED in relatively new range hood started flashing and unfortunately in this case was not an indicator to check/change filter. Voltage meter indicated problem was power supply, which was not accessible. Simple solution: cut wire to LED fixture and reconnect to power supply (ensure correct polarity), connect power supply to A/C. You will probably want to connect an On/Off switch. If so, install at INPUT side of power supply. Placing the switch at the output side will also work, however it will shorten the life of the power supply.
Byrl Thompson
2024-12-26 12:23:31
Defective design. The AC contacts are blocked by the plastic housing. There is no way to bend the stiff AC supply wires coming in around the housing and screws that hold the removeable guard plate.
Recommended Products