Your cart is empty.
Your cart is empty.Product Description
Fitment
It fits all trailers of different shapes and sizes. Works well on under 80 inches width truck, submersible boats, RVs, jet ski trailers, tractor vehicles, utility trailers.
Wire Connection Tips
Left Side：
White Wire- Ground White+ Yellow - Front side works with high brightness White+ Brown - Three sides works, front side is low brightness.
Right Side：
White Wire- Ground White+ Green - Front side works with high brightness White+ Brown - Two sides works, front side is low brightness
Carlos Valdes
August 8, 2025
Easy install, worked great!
Mark
July 11, 2025
Needed to re-wire trailer quickly. This kit has great lights and was easy to install. Seller delivered very fast! Also purchased adhesive lined heatshrink tubing and butt connectors to really seal up all the wire connections. Worked perfectly for my first attempt at wiring a trailer, and I would order again if I need to wire another trailer.
nate
June 25, 2025
Instructions were sparse, AKA a single 3x5 illustrated picture. They also left out how to wire the side marking lights. The lights look to be of great quality. Finish is good and they look to be sealed well. They are ultra bright and low power draw, a huge upgrade from the stock incandescent sold on most utility trailers. If I were to wire another trailer, I would use this exact kit.
Robert
June 14, 2025
I bought this set for an older model, small trailer that I own. Existing lights were beat up and I wanted to replace with LEDs. Tail lights, marker lights, plenty of wire with a quality plug attached and (questionable) connectors included. Also included were several red/white reflective tape strips as well. Installation instructions are very basic, you will need to read between the lines a bit to complete the install. Things I discovered as I installed: Needed to drill a hole in center of tail light brackets to accommodate new light wiring harness; had to drill new mounting holes for side marker lights; no information in kit on marker lights (red is hot and back is groung); I used my own bolts to mount new side marker lights; every light has its own ground so I needed to crimp my own ring on each wire to mount the ground wire to frame; there is also a ground required for the main harness to be mounted at the trailer tongue; the kit includes snap type connectors but they are not waterproof so I used my own waterproof connectors. I would still recommend this kit, but I did need to make various "adjustments" to fit my trailer. I suspect many of you will have the same challenges. Satisfied with the look and quality, just expect some customization.
Customer
April 28, 2025
Work great. Great price
Thomas S.
April 21, 2025
I liked everything except for the length of the white ground wire. It was about 6" too short, so I had to splice another short length of wire to make it work for my trailer. Not a big problem, but one that could be avoided by just making the length of the ground wire longer. Otherwise, I was able to thread the harness through my restored trailer (originally built in 1995), solder and use heat shrink tubing on the connections to the lights, and when tested, all of the lights worked properly. After sandblasting, repainting, bolting on a new 2" x 8" deck, adding new safety chains, and finally this wiring and light kit, it looks like a new trailer.
Brian Bigelow
March 21, 2025
Works great on my '99 Coleman popup camper.
Chris Mollahan
January 18, 2025
The kit was easy to install. The biggest problem that I had was the wiring harness was not long enough. I have a 10 x 5 utility trailer and I was 4 feet short in the rear. The trailer was designed only for the wiring to go down one side and then across the back. I had to splice the wiring going to the right turn signal by cutting wire from the other pig tail that was provided. I suggest that the manufacturer add 5 extra feet so there is no splicing. Plus, instead of wire nuts to connect wires use real wire connectors that you can crimp.
Recommended Products