Your cart is empty.
Your cart is empty.Dayton PSC and Shaded Pole blowers provide economical air delivery for general heating, cooling, ventilating, or component cooling. Typical applications include cooling greenhouses, blowers for wood and corn stoves, ventilating small buildings, cooling electrical enclosures and removing heat from machinery. The blowers are exact replacements for many OEM blowers with the same physical footprint. Forward curve wheels driven by Dayton motors are rated for continuous duty with all-position mount. These units incorporate balanced ball or sleeve-bearing motors with cast aluminum end shields. This provides greater heat dissipation and protection, reducing down time due to component failure and accidental damage. Direct drive blower wheels are dynamically balanced to reduce noise and vibration and to maintain CFM at higher static pressures.
Jeff
2025-08-01 12:46:13
like old one just no instructions so take a picture of the old before you remove it
Harry M
2025-07-21 18:08:25
Went to a stove store and was told there was no replacement for the motor on my wood burner. Went on Amazon and low and behold I found it. Took 15 minutes to install and I now have hot air blowing into the room, it is a little noisier.
mike
2025-06-10 15:38:06
Bought this product for my heatmor, said it would fit . ended up being to small .
Abigail Adams
2025-06-02 16:57:21
POWERFUL!! We bought 2 motors to replace the old motors on our wood-burning stove. WOW.... these new motors certainly get the job done. One of the new motors does the job of both old motors. Plus they arrived much sooner than I expected; THANK YOU for superior product and service.
Ray Jack
2025-05-29 18:03:49
Nice size and easy to use for ventilation. Using it for changing the air in my basement which has dampness when it's wet outside.
Jode
2025-03-19 18:39:51
This blower is superior to others because of the ball bearings.The first blower with bushing bearings only lasted a couple of years, this series/type lasted over two and would have gone on longerif the start winding had not failed. I am keeping the old one for parts, even the bearings spin like new yet.Very solidly made and easy to reorder due to brand name/part number designation.
dawn
2025-03-16 13:26:44
matched the one I have
Goat Farmer
2025-02-23 16:54:28
Blower is a little noisier than my original but it’s for my outdoor furnace so it doesn’t matter. Works as it should. Came with wrong wiring directions but it’s only 2 wires. It is important to get the polarity right or it will not run. Overall I’m happy with it.
Réal Lefebvre
2025-02-09 16:03:53
Pour un poêle à bois
Recommended Products
