Your cart is empty.
Your cart is empty. Installation
1. Using a lint free rag, wipe the oil off the valve body mounting surface.
2. Install the O-ring provided in the groove of the transmission filter extender.
3. After determining which length bolts are necessary for your transmission, install the bolts through the provided washers.
4. Using a 5 32” Allen Wrench, tighten the bolts.
5. Torque the bolts to a maximum of 14 inch pounds.
6. Install transmission pan and fluid.
Note:
Be careful when removing because the filter will still have fluid inside.
Jossie
2025-08-20 17:54:59
Machined from good quality material, worked great. Only issue I had is that it doesn't come with any instructions, had to go looking for the proper torque on the bolts.
Shannon
2025-07-31 14:19:12
This is a solid piece.Unlike the one I use to have that was 2 pieces of sheet metal with a tube that easily bent.This is a nice solid piece that came with all the correct bolts , gaskets and o-rings. Made it easy to extend the filter down for the deep transmission pan.
david simons
2025-07-23 13:26:38
Great product
Ed B
2025-07-12 18:15:50
I was able to bolt it in to lower the filter because I’m installed a deeper pan. Works great.
jamez
2025-06-23 12:17:53
Easy to install with the deep pan on my 1979 727 transmission
Shirley A.
2025-05-14 12:30:25
the spacer fit perfectly and the addition of the proper length bolts was a bonus.
jrodie
2025-03-05 14:00:56
It's exactly what I was looking for.
chris
2025-02-26 15:18:14
works as described and very simple
Rnm
2024-12-22 10:05:02
Worked out great
Recommended Products
