Your cart is empty.
Your cart is empty.This engine air intake hose was designed as a direct replacement for the original equipment intake hose. Engineered for a perfect fit and easy installation, it includes all necessary fittings. Made of quality materials for a long service life. This part is compatible with the following vehicles. Before purchasing, enter your vehicle trim in the garage tool to confirm fitment. [Honda Odyssey: 2005, 2006]
BooksWarmerYoungstown
2025-09-05 18:04:26
Perfect fit for odyssey. Note that this is very commonly changed part in odyssey
Customer
2025-08-21 14:39:58
little hard to install the clamp because the position of the bolt was in the down side, but finally it works.
C. Johnson
2025-08-15 14:39:31
Just like others, I had to cut the 2 rubber tabs off so the screws were accessible. Other than that, fits great and works great!
Matuse
2025-04-03 17:31:51
Part worked out ok but I had to modify it for my 2014 Odyssey. One of the clamps came installed backwards and the other one I had to cut the rubber tab to get it to slide around to where I could actually tighten it down. Once I did that it fit fine otherwise.
Tech_Geek
2025-03-04 17:29:03
Dorman and Amazon gives you the wrong information on this hose. P/N 629-159 is for the Honda Odyssey 2011-2017 model. P/N 629-020 is actually for the 2005-2006 model. I ordered both P/Ns and confirmed P/N 696-159 was the exactly replacement (fit, form, and function) for the damaged OEM hose in my 2011 Honda Odyssey EX-L.I returned P/N 696-020 to Amazon for a refund.
marshallrt
2025-02-24 11:23:02
Right fit, good price, what else is there to say
J.D.
2025-02-19 10:00:07
Easy install, quick arrival, perfect fit, better fit than original .
Tony
2025-01-28 17:59:41
Like others have said, you really need to cut off the little rubber nubs that positively locate the hose clamp. Do this so you can situate the clamp with the screw on top, facing the front of the vehicle. IF you don't, you'll have a heck of a time tightening this properly on your remaining intake pieces.It's very simple to modify, just remove the clamp, carefully cut off the nubs with a razer or a sharp knife (without cutting through the hose itself) and then put the clamp back on. You don't have to get the nubs completely removed, just enough so the clamp fits over it easily. Of course smooth is best, but it doesn't have to be perfect if you're nervous about your ability to safely cut it off.
Lu
2024-12-18 18:53:18
The hose is stiffer compared to the factory hose. Don't be afraid to force it in the placement.
John Sing-Cheong Chen
2024-12-05 14:18:29
1. The design is different. Fit exactly. No top mount indicator, so it is hard to know the exact orientation. This causes the smarter middle section hose to be difficult to install2. The clamp is different but provided. This causes installing difficulty. The new Dorman's boot clamp's angle faces a weird area which offers limited space to tighten the screw3. Cannot re-use original clamps hardware4. Quality is good
Recommended Products
$129.29
$ 53 .99 $53.99