Shopping Cart

Your cart is empty.

Your cart is empty.

DORMAN 699-101 Accelerator Pedal Position Sensor, Black

Free shipping on orders over $29.99

$33.18

$ 14 .99 $14.99

In Stock

About this item

  • Ideal replacement - this accelerator pedal position sensor matches the fit and function of the original sensor.Material:tpu
  • Plug & play installation - no special tools or programming required to install this sensor
  • Trustworthy construction - engineered in North America and made from high-quality materials for long life
  • Quality tested - this accelerator pedal sensor has undergone extensive testing to ensure proper function and a long service life
  • Ensure fit – to make sure this part fits your exact vehicle, input your make, model and trim level into the Amazon Garage


This direct replacement accelerator pedal position sensor matches the fit and performance of a failed original equipment sensor to restore proper vehicle operation. Made of quality materials for a reliable service life.


Kilroy
2025-09-04 16:42:37
Worked great on an old Chevy pickup
Steviemack
2025-08-23 10:11:08
Installed this on my 2004 Chevrolet Tahoe 5.3L after getting the P2135 code. Throttle body had already been replaced 3 f'ing times but not with an AC Delco. First Hitachi, 2nd Standard and 3rd Hitachi due to parts warranty. Decided to try replacing the Accelerator Pedal Sensor. Watched the A1 Parts video as a guide. Had to go to Lowes and buy the TT20 Torx security bit to remove the sensor from the gas pedal. In hidesight, I would have tried to remove it from the gas pedal a bit longer. I got one screw out easily but the other was wedged against the firewall preventing me from getting the Torx Socket on it. So I removed the gas pedal. Removal was quite easy but getting the top spring nut back on the stud was nearly impossible. After several hours of cussing and sweating my a** off I was finally able to get another M6-1.0 nut on the stud. Not the original spring nut as the nut spins and the washer remains stationary. This did not fix the issue. So I replaced the throttle body myself with the AC Delco 19420713 and gasket FEL-PRO 61070, Why the throttle body doesn't come with a gasket is beyond me! Throttle body removal and installation was completed in approximately 1 hour due to some complications with the spring clamps on the coolant lines that connect to the throttle body. Yes, coolant lines. WTF! Anyways, long story short I am back on the road with 300,500 miles and everything is working as it should. Will see if this permanently resolved the Reduced Engine Power mystery.
R.J.
2025-08-12 14:28:53
Seemed to fixed P0220 code. Not to difficult to replace and install. Tools needed were 10mm socket w/ extension, T20, and pliers.
Mr Gizmo
2025-06-30 15:16:06
Great part that works as designed, easy to install just have the right tools, requires a T-20 tamper proof torx socket or bit, also make darn sure you disconnect your vehicle's negative battery terminal before beginning any work, failure to do so will FRY your New sensor, an ounce of prevention is worth a pound of cure, IMHO I believe most of the Bad reviews for this part wasn't failure of part itself, but failure of the installer to disconnect battery power before installing, vehicles today are very complexed and can be beyond the skill set of the average DIYer. 🔧
Robert Hardy
2025-06-27 15:13:11
2003 tahoe no problems with it as of now
FatKatMOTO
2025-06-21 17:56:51
2003 Chevy tahoe came up with acceleration codeand put me in limp mode.Could be this switch or the throttle.I tried my luck and it fixed it..
Miguel Garcia
2025-05-21 16:21:14
Normally I will go to an auto parts store but I didn't have the time for it so bought on Amazon. So when I got it I install it in 10 to 15 minutes. It did got rid of the code p1125 so i took it for a ride around the block and work great, came back home turn the avalanche off for at least 5min and turn it on, the p1125 is back. I check every but every seem fine. The next day I went to junkyard and got me one for $ 5.42 ! So I install the one from the junkyard and it work. For 2 day no code p1125. Also I test the sensor for Amazon by reinstall it and the code p1125 was there , so I reinstall junkyard and the code p1125 was gone. I reinstall and uninstall these sensor 3 time to make sure everything was install right but the sensor from Amazon maybe a defective sensor. Either way just go to junkyard and get one it way better than this cheap aftermarket one.
Teodato C.
2025-05-01 14:15:10
Good for 2003 gmc yukun xl
mike
2025-04-11 12:58:09
Way better price than local and works great to. Fixed a intermittent stutter I was having
J R
2025-03-09 11:19:21
Great price compared to local parts stores and exact match, no surprises. Fixed P1125 code and "reduced engine power" on 2004 Tahoe when it went into limp mode.
Will
2025-02-15 12:18:17
A Perfect fit for 2004 chevy Silverado 2500hd
Jeffrey N.
2025-02-03 11:43:00
It says it will fit my vehicle but the connector does not match and it’s completely different than what’s on the pedal
Maynard Hebert
2024-12-27 18:35:46
This part is incorrect for listing. Non returnable. Recommend betting electrical parts for your vehicle directly from local stores or dealers. Amazon is not the plan for this
Recommended Products