Your cart is empty.
Your cart is empty.High quality double sided through-hole plated PCBs in various sizes and quantity. All PCBs are 1.6mm thick.
Hank
2025-08-26 10:08:24
Very well made and easy to trim to size.
pmgallo
2025-07-22 13:53:58
Double sided well made.
John F Hall
2025-07-09 18:26:13
These boards worked great for my pedalboard power project. I was able to solder all components and wires to the board with no issues. Also very easy to cut to size with an exacto knife and drill standoff holes with a dremel, no problem. I will use them again in future projects.
Maisie
2025-06-01 11:17:01
They seem to be of good quality. I had to do some abusive soldering, unsoldering and resoldering and there is no sign of damage.
Mind Stolen - Human rights. Stop torture.
2025-04-09 11:01:49
These PCB prototype boards are not bad. I was able to build some serious stuff using them. They are in good hands.
Maarten Hofman
2025-02-28 12:52:53
These protoboards are solid. The fact that they are double sided is very useful, and in most cases the solder flows well on them (they are not as good as the JLCPCB boards, but those are very hard to beat). They sometimes come attached to each other, but it turns out you can break them apart easily.
Jhon López Valencia
2025-02-08 16:33:58
Excelente terminado, funciona correctamente
truckfan
2025-01-05 15:14:43
You can buy similar boards in many different sizes. For what I do I like this specific size in both single- and double-sided forms. Per-board the price is decent if you buy 5 at a time and gets even better if you buy 10.Whatever size you buy, make sure that the copper pads are tin-plated. I bought some boards with copper pads and some others that appeared gold-plated but weren't, and it was a pain getting the solder to stick even after polishing them with a dremel wire wheel.These are easy to snap to smaller sizes. Use a sharp metal scribe (not an Xacto knife - they tend to take off in their own direction) and a metal ruler to scribe a deep line wherever you want to snap the board. Then lay it on a sharp edge and snap along the line. (I prefer to use pliers to bend the board because that gives a cleaner snap and is probably safer, too.)
Recommended Products
