Your cart is empty.
Your cart is empty.Bob
August 3, 2025
I have had all kinds of problems cutting hole in tile, ceramic pots. These bits have great ability to start at a 45 degree angle and c gain traction transferring seemingly to 90 degrees they cut without wobble or cracking the tile or a pot. The holes are almost perfectly round.I think the largest is 20 millimeters. I order again I think I want larger bits.I
Renee Rochelle
July 18, 2025
I enjoy these for my tiered plate projects
Paul Burke
July 17, 2025
Used this bit for drilling porcelain tile to set screws in the backer board...installing shower door kit..
David F Ramey
July 13, 2025
Used to put an anker bolt in quartz rock to move it
Maureen
July 2, 2025
My son had the hole in the floor enlarged in a matter of minutes. Fit right in our Ryobi drill.
Cedar
June 28, 2025
They did get the job done... But, thats because I only needed 4 holes and was willing to ruin 3 bits in order to do so. They may work on something thinner and/or softer than 1" granite countertops, but they didn't work well on mine. I do not recommend - especially if you want to use them more than once.
kpatel
May 20, 2025
Ehh.. these bits can drill a hole but they wear out very quickly. Or the tip breaks off. For the low cost this was expected.
George
April 18, 2025
These are great worked worked exactly as described for porcelain tile. I bought a couple extra because the stuff I purchased from another source worked so poorly, but was able to finish the job using only one of these bits.
Davis
April 3, 2025
Good prices for quality
Faizal
March 21, 2025
Very handy set and they do the job.
gert h.
February 8, 2025
Erfüllt den Zweck einwandfrei
ALLEMAND Tony
February 2, 2025
Je ne comprends pas les avis négatifs qui disent que ça casse facilement. Alors oui, même si il y a une sorte de graisse dedans, faut quand même mouiller en continue le carrelage et faire des poses de temps en temps pour ne pas que ça chauffe trop, et ce afin de ne pas abîmer les forêts trop rapidement, mais je témoigne que j'ai pu percer toute ma salle de bain avec sans aucun problème.
Roberto
January 7, 2025
Ho eseguito dei fori su mattonelle in gres porcellanato per fissare il box doccia, consiglio di mettere uno strato di nastro carta sulla mattonella nel punto da forare, all'inizio tenere leggermente inclinato il trapano e bagnare bene la punta.
Recommended Products