Your cart is empty.
Your cart is empty.Since 1959, the Broberg family has owned and operated DU-BRO Products, Inc. During that time, the company has grown from a single product, to 4 companies in three industries, offering more than 1,200 items. Innovation and reliability has been synonymous with DU-BRO for all these years and coupling that with great customer service and a knowledgeable, helpful staff, has made DU-BRO a staple line in all the industries they have taken on.
John Smith
2025-07-24 17:16:16
I broke down a few Victorinox Alox swiss army knives so that I could build my own custom one. I've done this quite a few times for either myself or friends that want something custom built. I like to tap the outside aluminox scale material so I can attach a pocket clip to it. I bought these after breaking a more expensive set from Knife Kits. I bought them primary due to the low cost and because they supported Prime shipping instead of the more expensive shipping from Knife Kits. These have worked perfectly. Not a single issue with either the drill bit or the tap and my screws hold as you would expect. I will definitely buy these again if either piece ever breaks.
Fred
2025-06-07 17:55:11
Du-bro Products are nothing short of Excellent, Excellent Prices and Excellent Quality.
Norman
2025-05-19 09:22:06
Broke the tap in aluminum first try. It broke when I was backing it out. You have to be real careful when using these very small taps.
Birdman
2025-04-08 14:05:40
Zero Complaints. These are a half the price of the hardware store and hobby grade. When used with plastic and other softer metals, I have tapped most holes by hand, no drill or tool needed. I use these to prep RC composites or chase RC metal threads for screws installs.
epicfail48
2025-02-14 11:34:21
Does what it says on the tin, it cuts threads well. Be warned, these are extremely delicate. No fault of the quality of the taps, of course, but with a tap this small, the slightest bit of binding or lateral pressure WILL snap them. Go slow and gentle, use plenty of fluid
Michael Pedroza
2025-01-04 18:55:35
using for hot wheelsWorks wellMake sure you lubeDrill and tap straight and you won't snap one1st time using a tap and its tiny but I havent snapped it, its not that brittle, its you drilling and tapping all crooked
RC Enthusiast
2025-01-03 09:14:40
dang tap broke chasing blind nuts from the same company? First thought was the blind nuts were junky but I bought a different brand tap and it work really well. No more Dubro 2-56 taps for me.
RedFangSeven
2024-11-19 10:40:27
I use this set for 1/64 Diecast car mods. The metal that I tap is not hard, soft pot metal used for Hot wheels, and matchbox cars. The drill bit sheared after about 10 uses, it was dull after 5 holes. The tap itself survived a bit longer but meet the same fate. I am cautious when taping to avoid braking or stressing the tool, even with careful handling and, lubrication, I still managed to sheer the tap, on the reverse at that! I use finger pressure to avoid over torquing the tap, I removed the leverage bar/pin from the tap holder To not over torque the tool. Spend a little more cash and get a stronger tool, unless you are tapping plastic!
Recommended Products
$65.99
$ 28 .99 $28.99