Your cart is empty.
Your cart is empty.Product Description
Measure OUTSIDE DIAMETER of pipe to ensure proper sizing.
Flashers brand pipe flashing is the ONLY pipe flashing 100% Made in the USA
Jackman Industries is a family-owned small business that employs an American Workforce. We have proudly manufactured our product in Salem, Oregon since 1992.
Credentials:
- Women-Owned Small Business
- Registered Small Business
- OR: MWBE - Minority and Women-Owned Business Enterprise
- OR: ESB - Emerging Small Business
- OR: DBE - Disadvantaged Business Enterprise
- CA: CPUC Clearinghouse
Please review the intended design use and applicable temperature ranges prior to purchase. Product failure may occur if used outside these parameters.
Flashers brand pipe flashings are intended to create a water-tight seal on pipe penetrations through metal roofing and siding. Flashers are NOT recommended for use on applications that exceed continuous temperature ranges, as listed. Ex: Single Wall pipe with Flashers pipe flashing mounted close to heat source. Product failure may occur with temperatures exceeding applicable ranges. Use on projects out of the scope of the intended use or temperature range will void any possibility of manufacturer replacement.
Please review the intended design use and applicable temperature ranges prior to purchase. Product failure may occur if used outside these parameters.
Cooper
2025-08-14 13:22:39
Common sense is needed for installation. Caulk, check! Self tapping screws, check! Common sense, check! I slid it onto my double insulated pipe to see where I needed to trim it and then did so. Secured my double insulated pipe on the inside with my metal strapping I purchased. Again, use of common sense is required. I only mention this after reading other reviewers comments. After pipe secured, I used a little WD40 on the pipe which helped it slide over the pipe. When it was in place I molded it around my metal siding. I used it on the side and not for a roof application to help with not have leaks later on down the road. I used “Through The Roof†silicone and then slid the sleeve up to the siding. Then secured it with self tapping screws for a nice tight fit. Afterwards, I ran a bead around it to make sure it was sealed up and no water can leak through. Super happy with the product and would purchase again.
dennis stephenson
2025-07-29 16:40:26
Looks nice and great quality
Michael
2025-06-08 14:31:12
Good replacement for my old boot. Sealed good, we’ll see how long it lasts? I added a metal shroud above it on the pipe to protect it from falling debris like hail and other natural disasters.
Crystal Miller
2025-05-20 18:03:46
We used them to vent our bathroom fan out of the room. It works very well and is easy to install.
Christian eiklor
2025-05-11 18:05:33
She works gotta use your silicone but she works!
Thomas
2025-05-10 14:19:43
Sealed to the roof. Ease to install .
Renee
2025-04-07 15:33:54
Adjusted to all three of our requirements of ur roof vent sizes.
Customer
2025-04-05 11:05:57
Very surprised by the sizeIt's flimsy and not much there to screw intoPrice is high
gaetan nenquin
2025-04-04 18:50:35
A très bien fonctionné pour un mini wood stove avec un pipe de 7cm, je l'ai eu 2 hivers complet dans une rollotte transformée en tiny house et très satisfait
Fudsky
2025-02-19 13:37:55
Well made fit my 8" b vent pipe for my wood stove
Cindy
2025-01-30 18:57:58
According to my husband this was exactly what he needed..
Terry la france
2025-01-11 10:43:27
good
Claude Robert
2025-01-09 17:39:13
Installer pour la cheminé de la maison. Très étanche.
Recommended Products