Shopping Cart

Your cart is empty.

Your cart is empty.

for Bridgeport Milling Other Milling Machines

4.8 (3) Write Review
Free shipping on orders over $29.99

$31.50

$ 15 .99 $15.99

In Stock
  • Quill Feed Handle
  • For Bridgeport type mills ; Bore Size: 1" ; The long-needed time-saving accessory for Bridgeport operators
  • Flick of the wrist retracts pin from index plate of the quill feed mechanism and lets you move handle into any desired position
  • Spring pushes pin back from quill feed actuation up of down and allows repositioning of the handle without removing it from the machine
  • Quantity: 1 ; Shipping Weight: 1.5 Lbs ; Overall length: 8-1/2''long



Max Mudge
2025-05-01 14:52:06
If you buy one of these, plan to take it fully apart. As delivered, lever binds, wouldn't allow the pin to pull back far enough to release. First thing I noted, the pivot pin for the lever wasn't even driven all the way through the lever, let alone into the other side of the body. Shards on the edges of hole, and the pin that is meant to engage the spindle handle hub bound in its hole. Clean up shards, bevel holes, clean up holes, and put in a proper pin for the lever to rotate on, should work fine. Otherwise, a piece of crap.
Richard E. Boggs
2025-03-20 17:07:43
A little beat up but with oil and some polishing it worked
Joe B.
2024-11-26 19:39:48
Not the best quality, the action is a little rough but som3 fin3 tuning with a file and some grease and it works OK.