Your cart is empty.
Your cart is empty.INSTRUCTION TMC2209 is the successor of TMC2208 that features all functions it has while dissipating less heat. It supports larger up to 2.8A and allows a maximum subdivision of 256, and infinitely zeroing. Product Name: TMC2209 driver Native Microsteps: up to 256 Peak Current: 2.8A Confguration: STEP/DIR and UART mode Factory Default Current: 1A Voltage: 4.75 - 29V IC Logic Voltage: 3.3/5V Effective Current: 2A Application: 3D printer main control board Weight: 3g FEATURES 1. The motor is not easy to lose its position, which improves printing quality; 2. Ultra- silent mode; 3. Large fan thermal pad improves heat dissipation of the driver; 4. Effectively prevent motor jtter to print more accurately; 5. Four-layer board welding process ensures more stable performance; 6. Stall detection with indicators; 7. Support STEP/DIR or UART mode 8. Easy to DIY and operate TIPS 1. Be sure to disconnect the power supply before installing the driver to prevent the driver from burning. 2. Before installing the driver, check the direction to prevent reverse connection (The reference board is the same as the module silkscreen). 3. Do not plug or unplug the driver while power is on. 4. When installing heat sink, be careful not to touch the heat sink and pin headers to prevent shorted circuit. 5. Make sure all cooling measures are ready before use (e.g. heat sink, flow air, cooling fan) 8. Use a power supply (12 or 24V DC) when measuring the voltage, do not use USB power supply only.
CED
2025-04-20 13:44:05
TMC2209s stepper drivers are generally all the same. However, I was really pleased to see that these have a lot of selectable options. The Pins are double-sided on the top and bottom. That makes getting communication with boards easier to do.The larger heatsink area is nicer too. I think these will likely last longer than others I have purchased.What I really liked about these is that they LED indicators for power various functions which help when troubleshooting.
Ralph M Marius
2025-02-15 14:05:29
This was 1st time I need to install one a new driver. Had an old Ender that needed to be replaced. Seems to be day and night difference. Much quieter and and cooler. Nice upgrade for my printer.
Raymond D Smith
2025-01-13 12:17:30
These tmc2209 silent drivers are perfect for my next upgrade! Quick and easy install!
GallantChaos
2024-12-27 15:55:34
These stepper drivers are so much quieter than the 4988 drivers I replaced! If you ever need to mute a 3D printer, this can definitely accomplish that. I didn't really have any other reason for changing out the steppers, although the spec sheet of Trinamic's 2209 driver is impressive. With these, you'll have far more control over the positioning of your printer.One thing to note: The jumper settings between this and the 4988 are different. Make sure you consult your documentation for both the old and new drivers (I found that the BTT 2209 manual on GitHub was similar enough to these drivers).
Todd
2024-11-26 16:35:09
I had a mainboard go bad on one of my 3d printers. I picked up a Geetech Spark E3 board and am using these stepper motor drivers to quiet it down. My old board used 4498 drivers and was loud. So far this is nice and quiet and I can run the machine without worrying about background noise during meetings and so for in the same room. I may end up upgrading my other systems to these drivers.
Recommended Products
