Your cart is empty.
Your cart is empty.
Product Description:
Push / Pull Quick-Release Toggle Clamp
is a must-have addition to your jig assembly. With its sturdy construction and efficient design, high-performing push/pull clamping action, this power house of a clamp delivers a hold that is versatile in application and resists slippage.
Oil and Stain resistant red vinyl solid hand grips.
Specifications:
Type: GH-302-FM Push / Pull quick release holding toggle clamp
Overall Size: 160 x 55 x 85mm/6.3" x 2.2" x 3.3" (L*W*H);
Hole Size: 5mm/0.2";
Hole Center Distance: 42 x 35mm/1.7" x 1.4"(L*W);
Plunger bolt thread model and size:
M8 screw ( 5/16-18 bolt ), 3.2cm / 1.26" inches long
Push rod range ( without clamp bolt ) from end of base to end of push rod: 21.5cm / 8.46" inches
Clamp height, including handle, when clamped:10cm / 3.94” inches
Total length when clamped ( without clamp bolt ):14cm / 5.51" inches
Package include: 1pc 302F Toggle Clamp.
Leah C.
2025-08-30 12:41:26
Used as a brake on a set piece for a play. Works well, easy movement, out of the way when locked.
michael keen
2025-07-29 14:34:32
Excellent item, Just what I wanted, Great value and a fast delivery
Q. Zbikowski
2025-05-30 15:07:31
Bought 4 for jigging and fixturing on a welding table.One of them hangs up a bit through the clamping stroke.Two of them, I had to run an M8 x 1.25 tap through the barrel as the tapping was finished poorly and the adjustment screw wouldn't feed smoothly.They lock up easily into the clamped position and the hold strength is tremendous.They're acceptable and work decently for an acceptable price.
VA- Do it yourselfer
2025-04-11 19:07:51
I used this clamp on a woodworking assembly fixture, works as expected, a great low-cost alternative to the brand name clamps.
Retired Old Guy
2025-02-28 10:20:26
Just right for my project, I replaced the bolt with a rubber bumper for a project on my table saw.
mt4ensics
2025-02-18 14:28:37
Product is well made but the manufacture did a poor job of cutting the threads for the plunger piece of clamp. Needed to take a tap and cutting fluid to clean the threads. Do not buy if you don’t have a tap and die set!
Ken S.
2025-01-12 13:56:10
Have this screwed to a board using as a pen press.
Ross
2024-12-01 14:57:48
These clamps were perfect for my application. They are very sturdy and have a smooth action with a satisfying clunk at each ends of the throw.I'm pretty impressed for the price. I plan to buy a few more of these for future projects.
Recommended Products
