Your cart is empty.
Your cart is empty.HHIP 45 Degree HSS single angle chamfer cutter use for chamfering and angle milling operations. Right Hand Cut. Measure: 1/2 cutter diameter x 1/8 cutter width x 3/8 shank diameter x 2-1/8 overall length.
Brian C.
2025-08-16 13:46:28
This is advertised as a chamfering tool, but it is actually a dovetail cutter. It is 90º out of spec and will not cut 45º chamfers on top of your part.
Bob K.
2025-08-05 15:28:07
This cutter is opposite of the picture shown. What was sent was a dove tail cutter which are priced significantly cheaper than the single Angle cutter advertised. The angle of the cutter is exactly 180 deg upside down and unusable for my project.
Karin Flowers
2025-08-02 17:51:58
The packaging says it contains chemicals that cause cancer. This was not advertised on the description page at the time I bought it. It doesn't say what chemicals they are, just that they cause cancer.
Charles Johnson
2024-11-12 18:35:54
Poor quality control. Cutters are cut at the wrong angle.
Recommended Products
$10.47
$ 4 .99 $4.99