Your cart is empty.
Your cart is empty.Product Description
Texture Touch Up Kit, Wall and Ceiling Texture and Sprayer
From the Manufacturer
Hand-operated sprayer comes complete with texture and is ideal for smaller patch and repair work. Provides an inexpensive way to match existing texture on small areas of walls and ceilings. Designed for repair of wall and ceiling splatter textures. The sprayer adjusts to disperse a variety of patterns such as orange peel, splatter and knockdown. The kit comes with one bottle of premixed spray texture, a small mud knife, and the sprayer.
David B.
2025-08-27 15:55:44
This device works great. Well,... it worked great, for about an hour, then it didn't. After a while, no matter how hard I pumped, the mud just dribbled out the end. After disassembling a few times, and playing with viscosity (to no avail) I found that the tiny compressed air hole at the head end of the cylinder was mostly clogged. I cleaned that orifice with water, and the device worked great again. This is not the exit orifice. It's the one hidden inside the device. You must remove the pump to access it. Maybe it clogged because I let the device sit for too long while I was knocking down.A lot of people complain about this dribbling, rather than spraying. Perhaps they just haven't learned how to keep the compressed air hole clean.Also, people recommend viscosities from thick paint to pancake batter. Both work, as well as anywhere in between. But lighter is easier to pump.I'll never again buy spray cans of texture for touch up. This is better.
Ivory
2025-07-29 11:26:43
This is a really great tool, but it does have some minor drawbacks, which is why I gave only 4 out of 5 stars. First off, it works great and helped me texture a repair on my ceiling with what I consider to be semi-professional results. I also like that I can reuse the tool for future wall or ceiling repairs and don't have to worry an opened can expiring over time since I dont use it that often. The tool is also easy to disassemble and clean with water to ensure it will keep working for years to come. A couple things I wish were different/better. The opening where the texture sprays out has no ability to close. Therefore, when you pour in the mixture, it begins to pour right out of the opening. I would carefully hold the canister and place my index finger over the opening as I poured in the texture. That helped keep it from dripping out. It would be better if the spray tip could be closed somehow during the "filling process" (e.g. a little plug that you can pop in and out). Also, it would be nice if the cap at the top could be removed so that you could fill the canister from the top. None of these things are major issues and I am very pleased with this purchase and glad I found it before buying another aerosol can of texture spray. I recommend it.
Rich
2025-07-04 17:31:39
This miniature hopper worked great to re-texture a light orange peel in a small area of my 1/2 bath.As per the instructions, I cut the plastic around the nozzle and used a nail to poke a small hole in the center of the red cap above the hopper portion of the device. I mixed some joint compound to about the consistency of thinned out paint knowing that the joint compound will thicken very quickly.I poured the mix into the hopper while covering the nozzle with my finger to avoid spilling. Once assembled, I started at the lowest setting and slightly increased it before every pump until I matched the existing texture. The result was close to a perfect match and completely inconspicuous.I had previously tried different methods including a texture sponge and spray cans but neither worked well. The texture using a sponge didn't match and the spray looked good when first applied but then shrank way too much.Clean-up was easy. Before spraying I laid out towels to protect the surrounding areas. I then tossed the towels in the washer when done.
Larry in FL
2025-05-24 18:36:14
This "tool" appears to be designed to make you give up and instead buy cans of overpriced texture spray. I have tried to use it several times, and can say it is one of the worst tools I have ever used.1. You cannot get the material into the little top.2. It holds very little.3. It does NOT spray evenly, and is dependent upon angle and how much you shake it to try to get materials down into the injector area.4. It is waaay more effort to pump than you would ever expect!5. It is a bear to clean up, as material sticks inside the little, tiny cup.
Amanda Daniel
2025-05-09 16:37:55
Ive textured walls before. I thought this would be better rhan the can stuff(which im not used ro useing) it was a little bit harder rhan i thought. I should have played with the product more before just using. After a few times it wasnt so bad, but messy. Easy to clean up.
Liz. Muchas gracias.
2025-04-30 14:53:32
Muy buen producto..mi esposo trabaja en construcción.y es para mejorar.
JES
2025-03-23 15:07:08
This item did not preform well for me. The mud was difficult to spray on the overhead areas.
Psoup
2025-03-18 11:27:11
I have used the cans, expensive and messy and once you use them they go dead so you cannot have one sitting and waiting for the next use. I have a full sized hopper to texture entire rooms and walls and had been looking at the local stores for a touch up solution... with no luck... I came across this one and thought it would be great to have on hand. Once I got it I was shocked at how small the instruction were... luckily I knew the concept on how to work it, the thing that threw me was having to cut off a part of it for the first use and puncture a hole... did I read that right? Hope so but the instruction print was so fricken small... but I did it anyway... it was obvious to me because the nozzle was covered up, free that puppy.I mixed my mud (although it comes with 3 packets of texture 2 of them is for popcorn ceiling...HUH? I thought people were removing popcorn and you give me 2 bags full?) I made my touch ups (ended up thinning the texture way down to allow for proper matching of my current wall... was pretty thin but this may be what you have to do. It made a huge mess... had to hold a towel below the nozzle because it wanted to splooge out all over the place. Once the texture was dry I was very happy... better than any results I have ever gotten out of a can.
laikayung
2025-02-20 18:37:15
Very cheap made product that doesn't even work. The popcorn won't come out of the nozzle no matter how big I make the hole to be. Also the popcorn is made of foam, which most certainly won't match your ceiling. I've tried everything to fix my ceiling, anything that's sold on Amazon (brash on popcorn, spray can, hand spray gun) none of them will give you a perfect match and in general just a waste of money and effort. Truth is, if you really want a good match, you need to create a patch the same way it was originally done. SO, my advice is to buy a bag of popcorn texture that matches your popcorn size(fine, medium, coarse), which will cost less than $20 for a 40 Lb bag (on LifeandHome online) then rent a hopper gun and compressor at your local tool store (another $30/day). With less than $50, you'll be able to do it professionally and get a perfect match to your existing ceiling. Stop wasting money on these quick-fix solutions.
José m.
2025-01-18 18:40:05
No sirve para empezar no sale el producto y se tira todo al tratar de aplicarlo no es lo q se ve en la imagen
Kristall
2025-01-13 13:35:42
No sirve para nada, seguà las instrucciones paso a paso. Nunca salió nada de la mezcla de la pequeña pistola, intenté ponerlo a mano y solo con tocarlo, se desprendió del techo, horas de intentarlo, para que no sirva ni la pasta ni la pistola, solo se ensució toda mi sala. Pésimo producto, quiero la devolución de mi dinero, aunque la de mi tiempo, nadie me lo va a regresar.
fJL
2024-12-18 17:32:10
Came apart in my hands after 4 storks/ pumps! NO GOOD
Recommended Products
