Your cart is empty.
Your cart is empty.Product Description
Home button installation step description:
The first step
Take out the parts as shown in the picture, separate them with your fingers, and keep the parts marked by the arrows in the picture.
The Second step
Tear off the circle gasket reserved in the previous step, and stick the sticky side to the button hole on the back of the touch screen. Please align and paste as much as possible.
The third step
Take out the buttons in the tool kit, as shown in the figure.
The fourth step
Put the back of the button up, and then put it into the button hole, as shown in the figure.
Home button installation step description:
The fifth step
Take out the parts (waterproof ring) as shown in the figure, and tear off the protective film.
The sixth step
Paste the sticky side on the button hole, please pay attention to calibration. Through this step, the waterproof ring can initially fix the button cable on the touch screen, as indicated by the arrow.
The seventh step
Take out the part (horns) as shown in the picture. The two sides of the part are sticky.
The eighth step
Paste the sticky side of the part on the key hole of the touch screen, and the center of the part is aligned with the center of the key hole, and the key change is installed.
At this point, you can test and press the button to see if the button can be pressed normally. If there is no response when pressing, please check whether the installation of all parts is fully calibrated.
Tamara
2025-08-20 17:02:55
Love it
Jason
2025-07-10 13:44:50
You wind up losing the finger print functionality if you don't swap a few other things over. If this switch works great and it's very reasonably priced. The finger print sensor isn't a deal breaker for me anyway so I didn't bother switching out additional parts.
Shay vigo
2025-05-11 10:19:49
My son breaks his tablet a lot. This is the 4th time I’ve ordered this button. Works perfectly
Larry Gary
2025-05-09 15:30:20
I dislike the fact that the plug was missing.
Havi
2025-04-14 09:20:32
I would not recommend this product. The home button feels sunken in now. My review is based solely on that.Also wish I took to someone with a professional micro soldering station that could move the thumb print chip over..
Gregory T.
2025-03-31 11:16:43
3 stars since it's not touch ID. Other than that it's good quality and does what's it's suppose to.
Linda
2025-02-24 09:41:31
It works and if anything changes I will come back and edit my review.
Chris
2024-12-05 12:37:45
I installed the home button with no problems. It works as a normal home button should minus the Touch ID feature, which is to be expected with any replacement. It came with all the parts listed and looks good installed.
Recommended Products