Your cart is empty.
Your cart is empty.THE DEADEYE Magentic Chip Collector securely attaches to magnetic surfaces and collects metal chips while cutting. Minimal profile provides improved visibility and access to workspace. Works with up to 2-1/2 in. diameter cutters.
mark morgan
2025-09-03 15:31:50
As always ideal has an excellent product
Francisco Torge
2025-08-28 18:43:00
Hace el trabajo, perfecto para mi
Edwin
2025-08-10 18:57:06
Do the work but is hard to clean it
Charles Fromme
2025-08-03 13:24:02
This beats the dirt bag from southwire, cleans up well, drill with confidence.
Samuel Hutchinson
2025-06-19 17:03:54
It’s a great idea however, with it being hot metal, it melted into the plastic really quickly Making it hard to clean
triphase
2025-05-21 13:47:14
Works amazingly well for even hole saw size holes (up to almost 2.5â€). It is so much faster and easier than trying to make a trap out of blue painters tape.PRO TIP: to ensure longevity and minimal frustration, wrap or coat this tool in something THIN (too thick will prevent good magnetic holding) and heat resistant. The magnets in this tool are over molded with plastic and drilling creates hot metal chips that can melt and embed themselves in the surface making it difficult to clean. Since we are primarily electronics people, we used polyamide (kapton) tape which works perfectly, but I’m sure there are other solutions. As a bonus, if it ever gets really dirty/ugly, you can always re-wrap it and it will be like new again.
zachary korman
2025-04-15 14:42:00
Perfect
brandon c christie
2025-03-07 10:47:49
Because it’s all plastic the metal chips just get melted into the plastic. Nightmare to clean without a compressor on hand or something. Cut my finger through my glove trying to remove the chips. Buy the racketeers one. Maybe a little less strong, but easier to clean.
Mortal Warrior
2025-01-17 16:41:48
The only negative part is hot metal melts into the plastic. Must wear gloves to clean after.
Recommended Products
