Your cart is empty.
Your cart is empty.Jack Richeson Armature Wire Figure mounted on a formica platform features pliable and non-staining wire. 15 in armature figure features sturdy steel backirons that are adjustable, so the figure can be easily positioned in sitting, standing or kneeling stances.
Does the job
2025-08-25 18:26:22
For sculpting smaller figures, this stand is the answer. Easily adjustable and well constructed. I highly recommend.
Christopher P.
2025-08-03 14:20:45
The item is good but not great. It’s shaped great in that it’s proportioned. But you’ll come to find out that the clay will tend to slide off. Not on its own but as you apply pressure. So I’d recommend twisted double wire all over the body. Also the washer/ring in the center must be buffed to not slice a finger. Mine would easily cut my finger. But my main concern is the bottom. The whole wasn’t tight enough. Perhaps it needed two bolts. I needed to screw the stick further before tightening the bolt, or the bolt was useless. So two is needed. But that would also mean they would have to drill a whole large enough for the bottom bolt to not hang lower then the wooden plate. therefore the wood can sit flat without dancing left and right as you need to concentrate. So you might have to work twice as hard to sculpt due to jiggly mistakes. I think it’s all common sense things by now so 3-4 stars should be given for quality of design. But if it’s something you could work with…… the product does what it does.
Chris
2025-06-18 10:32:02
Two of the three threaded pieces on this weren't fitted properly. Wing-nut was completely worthless. Other required two sets of vice grips to get them to connect. For something so simple they really did a crummy job.
Essam Alblooshi
2025-06-07 09:54:57
Excited
Keponoho'Ikaua
2025-05-10 15:41:19
Very disappointing item. First, the quality is below poor. Second, the size they send is not right. They place a 12" armature inside a box that says 15". In other words, I ordered a 15" and received a 12" armature; not once, but twice. Then one of the armatures came incomplete; therefore, impossible to use. A total disaster! Save yourself the aggravation and buy a different brand. This one is cheaper, but you get less than what you paid for.
CHARLOTTE BERGER
2025-03-31 11:43:58
It’s a moveable work. You can bend the arms and legs, wrap it with material, wire, etc. Love it!
Master Horne
2025-03-23 10:58:42
I have made 2 dancer sculptures using this armature and both turned out really well. First I bent the figure using measurements and pliers into human proportions and angles. Then I covered it with a thin layer of tin foil wrapped firmly with thin wire. I used Sculpey clay to create the bodies. The finished sculpture is then baked in my oven and it just fits. The wire supports the weight of the dancers legs. The neck is a little short but I extended the head out the top more to compensate. The figure bends with no trouble into shape. The only thing I don't like is the unfinished look of the base otherwise, I think this is a fine armature and I plan to use more.
Shannon Hair
2025-02-14 16:44:07
Great Quality. Great Service
Recommended Products
