Your cart is empty.
Your cart is empty. Torque ConverterGM TH350/TH40030-Spline10.75 in. Bolt CircleStall Speed: 2300-2700 RPM Please Note:Converter diameter may vary based on Core AvailabilityDoes not fit transmissions that require lockup or clutch convertersSmall (10.75 in. Diameter bolt circle) flexplate or dual pattern flexplate requiredFor Big Block applications, use JEGS XHD ConvertersFluid Capacity ChartPerformance Torque Converter General Application Chart *Advertised
Camshaft DurationRear Gear RatioEngine RPM Range & Compression RatioConverter RPM Stall Speeds **Stock to 260°Stock to 3.231000-4600
8 to 9.51500 to 1700Stock to 265°Stock to 3.231400-5000
8 to 9.51600 to 1800265° to 280°3.00 to 3.731600-6000
9.5 to 10.52200 to 2400280° to 300°3.55 to 4.562000-6500
9.5 to 113000 to 3400280° to 310°3.73 to 4.882800-7000
10 to 11.53500 to 3800290°+3.73+3400-8000
10.5 to 123500+* This chart is a guideline. The stall speed may vary in your application.** Recommended for use with Small Block engines...
Robert C.
2025-08-01 16:47:11
worried about durability but so far it's doing fine
Allan
2025-07-22 18:19:27
Item came in a reasonable time...well packaged and looks good.
Joni Marsh
2025-06-05 18:40:21
Exactly what needed
Ross Tolbert’s
2025-04-09 16:29:20
Price was very good for the quality of the product
Mark V.
2025-02-25 09:28:40
Just your typical converter
Nick Betz
2025-02-22 10:59:04
Defective from the factory. Neck Was to short didn't even reach the trans pump ears. Had to pay to return it.
Kenneth Knight
2025-02-10 17:29:02
This worked well with my application but I had to clearance the flex plate for it to bolt up but the flanges were welded on so inconsistencies are to be expected. Overall, it worked.
Customer
2025-02-08 18:38:31
Converter was used in my 2001 ss camaro th400 swap and the converter went bad within a mile of use. All was professionally installed and even got a second shop’s opinion on it. Not suitable for anything that has any amount of power
Recommended Products
