Your cart is empty.
Your cart is empty.Steve-o
2025-09-03 17:59:26
Bought this for my Oklahoma joe smoker. They all leak smoke and this solves the problem fit was perfect and all nuts were included.
Buckerou
2025-09-02 18:52:23
These LavaLock clamps are a must-modification for any Oklahoma Joe Highlander/Longhorn Smoker. They are a tremendous accessory that goes far in leak-proofing your new smoker. I lined the clamp up with the top part of the handle bracket. Then using a silver tipped marker, I marked the four holes. After center punching the marks, I drilled a 1/8" hole followed up with a 3/16" drill bit. The included hardware is 10x32x1/2" bolts and they fit perfectly. The only thing to keep in mind, check the back side for the weld spot. You will need to shift the clamp a bit so it doesn't fall on the weld bumps. These LavaLock clamps really work and one of the must have mods to do. I highly recommend them.I give the clamps âââââ and bet you will too!Thanks for Reading - ✌😉
Steven Engster
2025-06-29 13:51:52
These clamps were easy to install. Screws were the correct size for the thickness of metal on my Oklahoma Joe's smoker. Have not used them yet but I am sure I might need to adjust the tightness Once I start smoking this summer.
RS
2025-06-27 09:09:01
These are very easy to install and work as expected. My only complaint is that the screws which come with it are not long enough. I did have to go to the hardware store and buy longer screws. Minor inconvenience but no big deal. I highly recommend step drilling the holes.
Alan
2025-06-18 12:16:29
I bought these in anticipation of my Char Griller Competition Pro 8125 cook chamber door leaking like a 50 year old dry rotted tire. After installing the gasket around the edge... I didn't néed these. I kept them just in case, they are of great quality and seem pretty solid..... After all they are Lavalock.
Bosco
2025-06-01 16:40:50
Used the latches on a Cuisinart COS-118 charcoal smoker and was pleased with the result. These are not the least expensive latches by far, but the other ones I could find had rubber tips which might melt. These have a neoprene tip, which should hold up better. Came with all the necessary hardware. If you can use a drill on metal, you should be able to install if you take your time. Once installed and adjusted, does a great job holding the smoker door closed (I also put a felt seal on the door to retain the smoke).
Joey Bag a Donuts
2025-05-09 13:43:52
I purchased this set for my OK JOE smoker. Each lock has 4 holes which require 4 fasteners (screws/nuts) to secure the lock. My set included only 5 fasteners. Now I need to drive and purchase additional fasteners to complete the installation. Each lock was sealed inside its own bag. There was no evidence bag puncture where the hardware could have fallen out. They just cannot count to 8 and the quality control is absent. Other than that, the locks are great and do exactly what they are designed to do. No complaints about that.
Pete
2025-04-21 17:01:15
While it says it is intended for Oklahoma Joe Longhorn smoker, it installed easily in my custom smoker with 1/4" walls. I was concerned the provided screws would be too short, but they were perfect. My only ding is that the red rubber handle covers slide off the latch very easily. I might add some glue to it. This wasn't enough to lower the rating though.The latch is strong enough to secure my warped smoker cover.I would buy again.
Shane0
2025-04-20 14:37:59
These work well.Very happy with them.
dan
2025-03-23 10:51:02
bon
Mazin
2025-03-08 17:29:59
This is a low quality latch, not close to what expected at all.I had to add clamps for each to keep it from fell apart while instal it because it happened before I start to use it.Not recommend it and don’t spend your money in low quality products 👎ðŸ¼
Bernard
2025-02-20 16:01:26
Trop petits
Recommended Products