Shopping Cart

Your cart is empty.

Your cart is empty.

M18 Capacitive Proximity Sensor Switch Shield Type LJC18A3-5-Z/BX Detection 5mm 10-30VDC 200mA NPN Normally Open(NO) 3 Wires

Free shipping on orders over $29.99

$8.99

$ 3 .99 $3.99

In Stock

About this item

  • Mounting Hole Diameter: 18mm
  • Detecting Distance: 5mm±10%; Set distance:0-4mm
  • Output Type: NPN Normally Open(NO); Shield Type
  • Current Output: 200mA; Working Voltage: 10-30 VDC
  • Detection Object:Can detect any dielectric


  • Detection Object:Can detect any dielectric.
  • Delay Distance:10% below of the detection distance.
  • Supply Voltage:DC12-24V(6-36V) Impulse (p-p)10% below.
  • Comsuption Current:13mA below.
  • Control Output:300mA below.
  • Loop Protection :reversal connection protection,surge absorption,load short-circuit protection.
  • Ambient Temperature & Humidity:During operation , storage : individually-30~+65℃(no freeze ,no drew ) ,During operation,storage:individually 35-95%RH.
  • Insulation Impedance :50MΩ above ( DC500 megameter ) between charging part and shell.
  • Withstand Voltage : AC1000V 50/60Hz 1 min. between charging part and shell.
  • Temperature Influence : Temperature range-30~+65℃,at + 23℃,± 15% detection distance, Temperature range-25~+60℃,at +23℃,±10% detection distance.
  • Voltage influence : Inside ±I5% rated supply voltage range,at rated supply voltage value ,inside ± 10 % detection distance.

Jerry
2025-07-20 09:52:43
Received item in good condition - fast shippingThese M18 proximity sensor performed very well in my test,Operated well in the voltage range I tested it for - 10vdc - 15vdcHad no problem short term current of 158ma,Worked perfectly, did not even need to adjust sensor gain, maybe something that should be checked,Picked up wood at about 3/4 inch the way it came set, I will be using it for sawdust, so will update review if any problems later,For now I would have to recommend product as an inexpensive alternative to much more expensive sensors like $100-300 Allen Bradly but never for industrial as reliability is to much a concern,Would also for longer life if it is an option to use it at the low end of voltage rating, excellent for the hobbyist or for a wood working sawdust silo,
Fabiana Mendes
2025-05-30 10:16:14
This was what I needed. NPN 10-30VDC. This sensor has good accuracy, a light that signals when it is on and sensitivity adjustment. The diameter is M18, with 2 nuts for fixing. The cable has 3 wires for correct installation.
Alberto Villuendas
2025-01-07 14:36:43
ya habia comprado otro
Mr Abercombie
2025-01-02 17:48:27
The device is constantly 'on'. Control LED constantly on.