Your cart is empty.
Your cart is empty. Product Specification
Button head screws have a low domed head with a wider bearing surface than standard heads, and they offer a finished appearance, making them an ideal choice when a neat appearance is desired.
Flange Diameter 13.6mm
Head Height 3.3mm
Thread Diameter 6mm
Pitch Size 1.0mm
Screw Length 16mm
Allen Hex Drive 4mm
High Quality Stainless Steel 18-8 (304)
Package Included
25 x Flanged Button Head Socket Bolts/Screws
Mazdafun
2025-08-30 19:57:48
I purchased these to replace socket-head screws and flat washers that kept shaking loose. I almost lost a kickstand off my ebike due to that! I discovered they'd loosen every 2-5 rides, depending on how rough the road was and how long my ride was. I got tired of checking them all the time and Lock-Tite didn't seem to help as much as I'd have liked (the kickstand must put too much load on them as I hit potholes, etc.).From prior experience, I know wedge-lock washers like the ones from Nord-Lock are much better than star or split washers. However, they need a bit more bearing surface than is typical of most bolt heads.These are a perfect match for wedge-lock washers! Not only do they make full use of them, they also look great on my bike! Since I installed them, I've not observed them loosening at all. Unfortunately, this style in stainless isn't commonly found in most hardware stores. Fortunately for me, it is offered here!
GizmoGuy
2025-08-04 18:32:14
Great value and nice quality.
Swayzed
2025-07-24 11:01:30
I bought a Nissan Frontier truck used without the Utilitrack system. I was looking for ways to made clamps without buying Nissans expensive and bulky claps. Basically this bolt is what you need to install the system if your truck already has the Utilitrack system installed at the factory and removed at some point. These worked well and they were the right size for me. Hope this helps!
M.G.ROESEL
2025-07-12 14:00:28
Used to replace some stock/factory m10 bolts on my UTV headrest that rusted/turned brown and bled onto the pads.. They made the area installed "pop" with the shiny new stainless steel heads.
John R. Schaefer
2025-06-26 12:51:22
Worked well
Nstam
2025-06-17 18:37:16
Just what I needed for Toyota license plates
James Smith
2025-06-05 12:05:53
Screws arrived without rust and were machined cleanly. I had to replace two bolts that were damaged and these worked perfectly. The hex head was machined perfectly so they were easy to install and tighten.
Telecaster
2025-04-18 11:55:46
As advertised
Dean Mertens
2025-03-22 15:03:04
Exactly as described
Noé Robertson
2025-02-28 15:49:00
i mean, it's a bolt that bolted, 10/10 would screw again
Richard Muething
2025-02-24 18:48:35
The bolts were exactly as listed. They arrived on time. Good service from this vendor.
Marty Garlough
2025-02-09 21:42:02
Worked perfect for my table legs
Richard
2025-02-05 17:25:44
These machines screws worked great for what I needed them for. They were a bit long and I could not find any that were shorter so just had to cut some off to get the length I need.
Recommended Products
