Your cart is empty.
Your cart is empty.Clamp Kits for HV4 & HV6 Rotary Table M8 Thread .Epoxy Black Finish 2 Clamps, 2 Steps, 2 Bolts, 2 Tee nuts T nuts size 16 mm
BW
2025-05-24 14:41:57
I don't really have any dislikes even with one off center slot. But if you can see in the picture, the off-center slot in the clamp on the right provides more room for the clamp on the left. It works great. If I were to machine toe clamps like these, I would do the same thing. Thanks!
Effren R. Starks
2025-03-17 15:58:01
Fit standard small drill press.
eJohn
2025-01-13 10:04:22
These are really roughly finished. Threads bearly fit into the t nuts. Would not recomend, spend a little more money on a better set.
Recommended Products
$36.99
$ 16 .99 $16.99
$10.99
$ 4 .99 $4.99
$70.00
$ 31 .99 $31.99