Your cart is empty.
Your cart is empty.Product Description
Product Details
2 Position ON-OFF
- With blue led indicator on this Illuminated On-Off Rocker Switch,when button turned on.
Snap-in design
- Round rocker toggle switch need a 20mm/0.8" round hole; With a keyhole slot to prevent unwanted rotation.
Waterproof
- Our rocker switch is made of plastic case, which can be waterproof, dustproof and insulated.
- IP65 Water Resistant
Wide application
- It is suitable for the modification of automobiles, all-terrain vehicles, trucks, lorries, ships, yachts, motorcycles, and electronic equipment.
Rated Voltage and Current: 12V 20A
- Light should connect to 12V
- Contact Type: SPST
- Terminals: 3 Pins
Pre-soldered Wires
- 4pcs Waterproof Rocker Switch Blue LED Lighted with Pre-soldered Wires.
KDX
2025-09-05 14:55:46
Excellent quality. Zero problems. Exposed to the weather. I did silicone the rubber cover to make sure it stayed water tite. So far so good for the last five years. I've bought nearly 2 dozen of them so yes it has worked over time on multiple boats.
Richard D.
2025-08-19 13:38:17
Used for extra lights on tractor
Mike K
2025-08-17 15:02:11
These were a good switch for my golf cart. I had several toggle switches that were going bad. I replaced them with these and not only do they look great they are very functional.
Steve Smith
2025-08-03 09:11:47
Bought these for my grandsons kayak. We put a fish finder and lights on it and these switches worked perfectly.
Mike & Steph Whitson
2025-06-06 10:18:21
The light up buttons were a perfect solution for my beach buggy - we kept leaving the under lights on and killing the battery on accident. Having this as a more visible on / off was great. Button was easy to install- drilling was a larger hole than I had before but the button works perfect and looks great.
muckamuck
2025-06-01 13:01:09
Work fine so far. Switch lights up even if switch is off. Will update after a year at sea.
Sergio champion
2025-03-08 17:42:33
the switch is great, led is bright, listing just needs to inform the buyer that the wire is soldered on to the plug so If you are replacing a switch that you have connectors already installed you will have to clip the and use butt connectors or un solder the wire off
Duffman
2025-02-22 12:50:57
Works as should got the job done
Customer
2024-12-21 14:10:39
worked for me, just had to make a plate to mount it
Recommended Products